ATEN VS98A 2/4/8-Port Video Splitter User Guide
- June 7, 2024
- Aten
Table of Contents
ATEN VanCryst™
VS92A/VS94A/VS98A
2/4/8-Port Video Splitter
Quick Start Guide
© Copyright 2020 ATEN® International Co., Ltd.
ATEN and the ATEN logo are trademarks of ATEN International Co., Ltd. All
rights reserved. All other trademarks are the property of their respective
owners.
Part No. PAPE-1285-I02G Printing Date: 11/2020
Package Contents
1 VS92A/VS94A/VS98A Video Splitter
1 Power Adapter
1 User Instructions
(A) Front View (VS98A)
Rear View (VS98A)
(B) Single Stage Installation
(C) Cascading
Support and Documentation Notice
All information, documentation, firmware, software utilities, and
specifications contained in this package are subject to change without prior
notification by the manufacturer.
To reduce the environmental impact of our products, ATEN documentation and
software can be found online at
http://www.aten.com/download/
Technical Support
www.aten.com/support
Scan for more information
ATEN Website
Requirements
Source Device
The following equipment must be installed on the computer or source device that acts at the source of video content:
- HDB-15 Output Connector
Display Device(s)
A display device with an HDB-15 input connector for each output port you will be installing.
Notes:
- The VS92A/VS94A/VS98A supports VGA, XGA, UXGA, WUXGA and multisync monitors.
- If you connect a DDC type monitor the Video Out Port 1, all other monitors must be able to support the highest resolution that the DDC monitor can provide.
Cables
- A high density HDB-15 video extender cable for the video source device
- A high density HDB-15 video extender cable for each display device you will be installing
(A) Hardware Review
Front View
1. Power LED
Rear View
2. Power Jack
3. Video In Port
4. Video Out Ports
Hardware Installation
(B) Single Stage Installation
In a single stage installation, no additional video splitters are cascaded from the first unit. To set up a single stage installation, do the following:
- Use a high density HDB-15 male/female video extender cable to connect the PC or source device’s video port to the Video In port on the rear of the Video Splitter.
- Use 2/4/8 high density HDB-15 male/female video extender cables to connect 2/4/8 monitors/display devices to the Video Splitter’s Video Out ports located on the rear panel.
- Plug the power adapter that came with the package into an AC power source; plug the power adapter cable into the Video Splitter’s power jack.
- Power on the Video splitter; power on the monitors/display devices; power on the PC/source device.
(C) Cascading
To provide even more displays, additional units can be cascaded from the Video Splitter’s Output ports. Simply use additional high density HDB-15 male/female video extender cables to connect any available Video Out on the parent splitter to the Video In port on the child splitter. See number 5 in the installation diagram.
You can cascade as many VS92A/VS94A/VS98A units as there are ports available, and all three models can be mixed on the same cascade.
VS92A/VS94A/VS98A 2/4/8-Port Video Splitter www.aten.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>