TOOLCY 2030 PSI MAX Electric Pressure Washer User Manual

Table of Contents

TOOLCY 2030 PSI MAX Electric Pressure Washer.jpg

This pressure washer is designed for cleaning cars, motorcycles, decks, driveways, grills, house siding, patios and outdoor furniture.

6. Power Cord

Connect a 3/4″ GHT standard “Garden Hose” (not included) to the rear water inlet of pressure washer.
Attach the “Leak-Proof Adapter” to the front outlet.* (Some batches may come with the adapter pre-attached on the “High Pressure Hose”.)
Connect the “High Pressure Hose” to the front water outlet of pressure washer.
Select a “Nozzle” and attach it to the “Extension Wand”.
(NOTE: Each of the nozzles has a different spray pattern. Determine the best nozzle for the job before starting a cleaning job.)
Attach the “Extension Wand” to the “Spray Gun”.
Connect the “Spray Gun” to the “High Pressure Hose”.
Turn on the “Water Supply” and run cold water source through the machine to purge any trapped air. (NOTE: Make sure that all the connections are tight and have no leakage before operation.)
Plug the “Power Cord” into the electrical outlet.
Turn the switch to the “I” position to turn the machine on.
Your pressure washer is now ready for use.

This pressure washer is equipped with a Ground-Fault Circuit
-Interrupter (GFCI) built into the plug of the power cord. This device provides additional protection against the risk of electric shock.
If the plug or cord needs to be replaced, use only identical replacement parts that include GFCI protection.
Test Ground-Fault Circuit-Interrupter (GFCI) Before Each Use.

FRONT OVERVIEW

FIG 1 FRONT OVERVIEW.JPG

BACK OVERVIEW

FIG 2 BACK OVERVIEW.JPG

CAUTION
Before starting the machine:

****WARNING

IMPORTANT SAFETY INSTRUCTIONS

DO NOT allow children to come into contact with the tool.
To reduce the risk of injury, close supervision is requiredwhen a product is used near children.
Supervision is required when inexperienced operators use this tool.

WARNING

To reduce the risk of serious personal injury, disconnect the pressure washer from power source before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury.
Do not operate the product when fatigued or under the influence of alcohol or drugs.
Do not touch plug or outlet with wet hands.
Never direct water spray at any electrical wiring or directly at the pressure washer itself as it may result in a fatal electric shock.
Move the switch on the machine to the OFF position before plugging or unplugging power cord to prevent accidental startup.
Wear safety goggles when operating. Wear protective clothing and footwear to protect against accidental spraying.
Do not touch nozzle or water spray during operation. Never place hands in front of nozzle.
Stay alert – watch what you are doing.
Keep operating area clear of all people and animals.
Disconnect the power plug when not in use and before disconnecting the high pressure hose.
Do not stand on unstable surfaces. Maintain good footing and balance at all times.

**** CAUTION

Never carry your pressure washer by the cord. Do not pull on the cord to disconnect from the outlet.
To prevent damage, the cord should not be crushed, placed next to sharp objects or near a heat source.
Check power cords before using. Damaged cords can reduce performance of pressure washer or cause a fatal electrical shock.
The pressure washer should not be used in areas where gas vapors may be present.
An electric spark could cause an explosion or fire.
Use only hoses and accessories rated for pressure higher than your pressure washer’s psi.
Always store your pressure washer in a location where the temperature will not fall below 4 °C.
Freeze damage is not covered by the warranty.