ADLER 6130.NG Media Sideboard Instruction Manual
- June 3, 2024
- ADLER
Table of Contents
6130.NG Media Sideboard
Instruction Manual
6130.NG Media Sideboard
FURNITURE TIPPING RESTRAINT FOR ADLER MEDIA SIDEBOARD
Young children may be injured by tipping furniture and the use of a tipping
restraint is highly recommended.
When properly installed, this restraint could provide protection against the
unexpected tipping of furniture due to small tremors, bumps or climbing. We
recommend mounting this restraint to a wall stud.
WARNING: This product is only a deterrent. It is not a substitute for
proper adult supervision.
TIPPING KIT CHECK LIST
| CODE | COMPONENT | QTY |
|---|---|---|
| 01 | PLASTIC STRAP | 2 |
| 02 | SCREW | 8 |
| 03 | NYLON WALL PLUG | 4 |
| 04 | PLASTIC BRACKET | 4 |
Installation Instruction:
- Attach one of the plastic brackets (04) securely near the top back edge of the furniture piece by inserting the screw (02). Refer to picture A.
- Determine the final position of the furniture piece. Mark location on the wall approximately 2” below the plastic bracket (04) mounted to the back of the furniture.
- Drill a starter hole into the wall stud. If wall stud is not available, drill a hole into the wall and insert nylon wall plug (03). Gently tap plug until the flange of the plug is flush with the wall.
- Attach a second plastic bracket (04) by inserting and securing the screw (02) to the wall. Refer to picture B.
- Align the two plastic brackets (04).
- Thread the plastic strap (01) through both plastic brackets (04) and tighten until snug.
- Check to make sure that the plastic brackets (04) are firmly installed the plastic strap (01) is secure.
- Repeat steps 1-7 at other end of furniture piece.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>