ADLER AD 8085 Mini Fridge User Manual
- October 30, 2023
- ADLER
Table of Contents
ADLER AD 8085 Mini Fridge
Product Information
The AD 8085 is a mini fridge that can be powered by an AC220-240V power supply or DC 12V. It has a 4L capacity and features a control panel (1A), a fan (1B), and a mini fridge chamber with an aluminum cavity (3A) that includes a shelf (3B), mini basket (3C), handles (3D), and mirror (3E). The device comes with a power supply cable for the home electrical installation (1D) and a car power cable (1C). The power consumption on each setting is as follows: AC – Heating mode 38W / Cooling mode 42W, DC – Heating mode 32W/Cooling mode 36W.
Product Usage Instructions
- Before use, ensure that the device is not connected to the power source.
- To power the device using an AC220-240V power supply, follow these steps:
- Plug in the connector to the AC slot (2D).
- Set the voltage switch (2B) to AC.
- Insert the other end of the cable with the plug (1D) into the electric socket.
- Set the mode switch (2A) to HOT when you want to heat the chamber or COLD to cool the chamber.
- To power the device using DC 12V, plug in the car power cable (1C).
- After finishing the operation, set the mode switch (2A) and voltage switch (2B) to OFF and disconnect the wires.
- Cleaning and maintenance:
- Before cleaning, make sure that the device is not connected to the power source.
- Use a damp cloth with a little washing-up liquid to clean the inside and outside of the device’s body. Do not use abrasive, rough, or other such sponges, papers, cloths, or towels as it may damage the device.
- Do not submerge or wet the device.
- Do not put any foreign objects into the fan to clean it.
- Dispose of the cardboard packaging as waste paper. Pour the polyethylene bags (PE) into the plastic container. Worn devices should be returned to the appropriate point storage because it is dangerous in the device ingredients may pose a threat to the environment. The electrical device should be handed over to limit its reuse and use. If in the device there are batteries, you have to take them out and give them to the point stored separately.
IMPORTANT SAFETY INSTRUCTIONS
GENERAL SAFETY CONDITIONS IMPORTANT SAFETY INSTRUCTIONS READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
- Before using the device, read the operating manual and follow the instructions contained therein. The manufacturer is not liable for any damage caused by the use of the device contrary to its intended use or improper operation.
- The appliance is intended for domestic use only. Do not use for other purposes not in accordance with its intended purpose.
- The device should be connected to a 220-240 V~ 50Hz socket or a 12 V cigarette lighter socket. In order to increase the safety of use, many electrical devices should not be connected to one electric circuit simultaneously.
- Be especially careful when using the device when children are in the vicinity. Do not allow children to play with the device and do not let children or people unfamiliar with the device use it.
- WARNING: This equipment may be used by children over 8 years of age and people with reduced physical, sensory or mental abilities, or people with no experience or knowledge of the equipment, if this is done under the supervision of a person responsible for their safety or has been provided to them. instructions on the safe use of the device and are aware of the dangers associated with its use. Children should not play with the equipment. Cleaning and user maintenance should not be performed by children, unless they are over 8 years old and these activities are performed under supervision.
- Always remove the plug from the outlet after use, holding the outlet with your hand. DO NOT pull on the cord.
- Do not immerse the cable, plug and the entire device in water or any other liquid. Do not expose the device to weather conditions (rain, sun, etc.).
- Periodically check the condition of the power cord. If the power cord is damaged, it should be replaced by a specialist repair shop in order to avoid a hazard.
- Do not use the appliance with a damaged power cord, or if it has been dropped or damaged in any way, or if it is not working properly.
- Do not repair the device yourself as there is a risk of electric shock. Take the damaged device to an appropriate service center for inspection or repair. Any repairs may only be carried out by authorized service points. Incorrectly performed repairs can pose a serious threat to the user.
- Place the device on a cool, stable, even surface, away from any kitchen appliances that heat up, such as: electric cooker, gas burner, etc..
- Do not use the device near flammable materials.
- The power cord must not hang over the edge of the table or touch hot surfaces.
- Do not leave the device or the power adapter in the socket unattended when it is switched on.
- For additional protection, it is advisable to install a residual current device (RCD) in the electrical circuit with a rated residual current not exceeding 30 mA. A specialist electrician should be consulted in this regard.
- Only original assembly parts and power cables supplied by the manufacturer in the set with the device should be used.
- Do not overload the refrigerator. The cover must close freely.
- WARNING: Be careful that the products stored inside do not cover the vent.
- Use the refrigerator in an upright position only.
- Do not expose the refrigerator to direct sunlight, rain, snow, excessive moisture, etc..
- Exercise particular caution when transporting the switched-on device in a car. Protect against falling while driving.
- WARNING: Keep space around the ventilation openings. Covering them will reduce the cooling capacity and may damage the refrigerator.
- Never connect the power cord to both the cigarette lighter and the electricity supply to the refrigerator at the same time.
- Only ready-made (wrapped) articles may be stored in the refrigerator.
- Prevent the appliance from being upside down. Don’t drop or shock it.
- Store food in original packaging or containers intended for this purpose.
DEVICE DESCRIPTION
- 1A. Control panel
- 1B. Fan
- 1C. Car power cable
- 1D. Power supply cable for the home electrical installation
- 2A. Mode switch – heating (HOT) / switching off (OFF) / cooling (COLD)
- 2B. Voltage switch – DC (12V ) / switching off (OFF) / AC (220-240V~)
- 2C. Car power socket 12V
- 2D. 220-240V~ power socket
- 3A. Mini fridge chamber with aluminum cavity
- 3B. Shelf
- 3C. Mini basket
- 3D. Handle
- 3E. Mirror
USING THE APPLIANCE
-
Ensure that the power switch (2A) on the control panel (1A) of the refrigerator is in the OFF position.
-
Device operation:
With 12V DC power supply:-
Insert the other end of the cable with the plug (1C) into the cigarette lighter socket.
-
Set the voltage switch (2B) to DC.
-
Plug in the connector to the DC slot (2C).
-
Set the mode switch (2A) to: “HOT” when you want to heat the chamber or “COLD” to cool the chamber.
The power consumption on each setting is as below: -
DC: Heating mode 32W / Cooling mode 36W
With AC220-240V power supply: -
Plug in the connector to the AC slot (2D).
-
Set the voltage switch (2B) to AC.
-
Insert the other end of the cable with the plug (1D) into the electric socket.
-
Set the mode switch (2A) to: “HOT” when you want to heat the chamber or “COLD” to cool the chamber.
The power consumption on each setting is as below: -
AC: Heating mode 38W / Cooling mode 42W
-
-
After finishing operation, set the mode switch (2A) and voltage switch (2B) to “OFF” and disconnect the wires. WARNING: Don’t switch the mode switch (2A) abruptly. Switch the function after 30 minutes of being on position: OFF.
Cleaning and Maintenance
-
Before cleaning make sure that the device is not connected to the power source.
-
The cleaning process is restricted to using a damp cloth with a little of washing up liquid on the inside and outside of the devices body.
NOTE: DO NOT PUT ANY FOREIGN OBJECTS INTO THE FAN TO CLEAN IT. -
Do not submerge or wet the device.
-
Do not use abrasive, rough or other such sponges, papers, cloths or towels as it may damage the device.
TECHNICAL DATA
- Power supply: AC 220-240V ~ 50Hz.
- Power: heating 38W, cooling 42W
- Power supply: DC 12V.
- Power: heating 32W, cooling 36W
- Capacity: 4L
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container Worn device should be returned to the appropriate point storage because it is dangerous in the device ingredients may pose a threat to the environment. The electrical device should be handed over to limit its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
Available Other Product
AFTER-SALE SERVICE NOTICE
If you want to buy spare parts or make any complaints, please contact the
seller who issued the receipt directly.