LINKSYS MR6350 Dual Band WiFi Router AC1300 User Guide
- June 6, 2024
- Linksys
Table of Contents
LINKSYS MR6350 Dual Band WiFi Router AC1300 User Guide
Wireless Regulatory Information
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and devices
- Connect the equipment to an outlet other than the receiver’s
- Consult a dealer or an experienced radio/TV technician for assistance
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
2.4GHz operation of this product in the USA is firmware-limited to channels 1 through 11.
The device for the band 5150-5250 MHz is only for indoor usage to reduce the potential for harmful interference to co-channel mobile satellite systems.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 35 cm between the radiator and your body.
This device and it’s antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
Innovation, Science and Economic Development
Canada Statement
CAN ICES-3 (B)/NMB-3 (B)
This device complies with ISED’s license-exempt RSS standards.
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device. For
product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive codes where required by the technology.
Innovation, Science and Economic Development
Canada Radiation Exposure Statement
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 35 cm between the radiator & your body.
This device and it’s antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with ISED multi-transmitter product procedures.
Restrictions in the 5 GHz Band
The device for the band 5150-5250 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel mobile satellite systems.
This device has been designed to operate with an antenna having a maximum gain of 2.93 dBi and 3.18 dBi at 2.4 GHz and 5 GHz respectively. Antenna having a higher gain is strictly prohibited per regulations of ISED. The required antenna impedance is 50 ohms.
The maximum antenna gain (Please see the table below) permitted (for devices in the bands 5250-5350 MHz and 5470-5725 MHz) to comply with the EIRP limit and the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the EIRP limits specified for point-to-point and nonpoint- to-point operation as appropriate because high power radars are allocated as primary users (meaning they have priority) in 5250- 5350 MHz and 5650-5850 MHz, these radars could cause interference and/or damage to license exempt LAN devices. The worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in Section 6.2.2(3) shall be clearly indicated.
Additional requirements for the band 5600- 5650 MHz
Until further notice, devices subject to this Section shall not be capable of
transmitting in the band 5600-5650 MHz, so that Environment Canada weather
radars operating in this band are protected.
Model: MR6350/MR6340/MR6330/MR6320
Note 1: “Exceeding 0.1 wt%” and “exceeding 0.01 wt%” indicate that the percentage content of the restricted substance exceeds the reference percentage valuhe of presence condition.
Note 2: “○” indicates that the percentage content of the restricted substance does not exceed the percentage of reference value of presence.
Note 3: “–” indicates that the restricted substance corresponds to the exemption.
Safety Notices
WARNING: Do not use this product near water, for example, in a wet basement or near a swimming pool.
WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
WARNING: The power adaptor is the equipment´s disconnection device. The power outlet must be located nearby the equipment and its access must be easy.
EU Declaration of Conformity
Hereby, Belkin International, Inc. declares that the radio equipment is in compliance with Directive 2014/53/EU.
The full text of the EU Declaration of Conformity is available at the following internet address: http://www.linksys.com/DoC/
Belkin Ltd. (UK) c/o Belkin BV
Herikerbergweg 106, Plaza Arena – Jupiter, 1101 CM Amsterdam,
The Netherlands
National Restrictions
Caution:
This device is restricted to indoor use only when operating in 5150 – 5350 MHz
for below EU countries:
Antenna Restrictions
This product is designed for use with the standard, integral or dedicated (external) antenna(s) that is/are shipped together with the equipment.
Third-Party Software or Firmware
The use of software or firmware not supported/provided by Linksys products may result that the equipment is no longer compliant with the regulatory requirements.
EU Radiation Exposure Statement
This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 35cm between the radiator and your body.
WEEE Information
User Information for Consumer Products Covered by EU Directive 2012/19/EU on Waste Electric and Electronic Equipment (WEEE)
This document contains important information for users with regards to the proper disposal and recycling of Linksys home networking products. Consumers are required to comply with this notice for all electronic products bearing the following symbol:
Environmental Information for Customers in the European Union
European Directive 2012/19/EU requires that the equipment bearing this symbol
on the product and/or its packaging must not be disposed of with unsorted
municipal waste. The symbol indicates that this product should be disposed of
separately from regular household waste streams. It is your responsibility to
dispose of this and other electric and electronic equipment via designated
collection facilities appointed by the government or local authorities.
Correct disposal and recycling will help prevent potential negative
consequences to the environment and human health. For more detailed
information about the disposal of your old equipment, please contact your
local authorities, waste disposal service, or the shop where you purchased the
product.
External Power Supply Information for Customers in the European Union
External Power Supply Energy Efficiency Information per EU Ecodesign Directive 2009/125/EC, commission regulation (EU) 2019/1782 of October 1, 2019.
Primary External Power Supply Information
Alternate External Power Supply Information
Visit linksys.com/support for award-winning
24/7 technical support
Belkin, LINKSYS and many product names and logos are trademarks of the Belkin group of companies. Third-party trademarks mentioned are the property of their respective owners. © 2020 Belkin International, Inc. and/or its affiliates. All rights reserved.
Read More About This Manual & Download PDF:
References
- Linksys Official Support - European Declaration of Conformity
- Linksys Official Support - User Guides, Downloads, FAQs
- Linksys | Networking & WiFi Technology
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>