CYOEST100 DIY Bluetooth Speaker Box Kit Instruction Manual
- June 5, 2024
- CYOEST
Table of Contents
CYOEST100 DIY Bluetooth Speaker Box Kit Instruction
KEY POINT: Make sure you know how the circuit is connected before
starting the installation
step1 :Install the board with four 6MM(long) screws
step2: Insert the wire into the red terminal of the panel
step3 :Install the battery pack with two 4MM(short) screws
step4 :Install the speakers with 4MM(short) screws
step5 :Pay attention to the position of the red circle
step6 :Install as Picture
step7: The wires of speakers are plugged into the white terminals. The black wire of the panel connects the black wire of the battery pack.
step8 :Install as Picture
step9 :The remaining two wires are connected to the switch.
step10 :Install 6MM screws in all small round holes. Install 4 batteries
(not included),push the switch to ON.finished!
BLUETOOTH CONNECTION
- Install the batteries
- push switch to “on”
- find “Z-horse Bluetooth speaker”
- connected
FCC Warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>