Dynojet Honda CB1100 Power Commander Fuel Controller Installation Guide
- June 3, 2024
- Dynojet
Table of Contents
Dynojet Honda CB1100 Power Commander Fuel Controller
PARTS LIST
- 1 POWER COMMANDER 6
- 1 INSTALLATION GUIDE
- 1 USB CABLE
- 2 DYNOJET DECALS
- 2 POWER COMMANDER DECALS
- 2 VELCRO STRIPS
- 1 ALCOHOL SWAB
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.
INPUT ACCESSORY GUIDE
OPTIONAL ACCESSORY INPUTS
Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps.
You can switch on the fl y between these two base maps when you hook up a
switch to the MAP inputs. You can use any open/close type switch. The polarity
of the wires is not important.
Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
Insert the wires from the Dynojet quick shifter into either Input 1 or Input
2. The polarity of the wires is not important. Set to Input 2 by default.
Speed If your application has a speed sensor then you can tap into the
signal side of the sensor and run a wire into this input. This will allow you
to calculate gear position in the Control Center Software. Once gear position
is setup you can alter your map based on gear position and setup gear
dependent kill times when using a quickshifter. .
Analog This input is for a 0-5v signal such as engine temp, boost, etc.
Once this input is established you can alter your fuel curve based on this
input in the Power Core software.
Launch You can connect a wire to either Input 1 or Input 2 and then the
other end to a switch. This switch when engaged (continuity) will only allow
the RPM to be raised to a certain limit (set in the software). When released,
you will have full RPM.
WIRE CONNECTIONS
To input wires into the PC6 fi rst remove the rubber plug on the backside of
the unit and loosen the screw for the corresponding input. Using a 22-24 gauge
wire, strip about 10mm from its end. Push the wire into the hole of the PC6
until it stops and then tighten the screw. Make sure to reinstall the rubber
plug.
NOTE: If you tin the wires with solder it will make inserting them
easier.
INSTALLING THE POWER COMMANDER 6
-
Remove the seat and the side panels directly below the seat on both sides.
-
Remove the fuel tank, and the plastic panel on the left side of the air box.
-
Remove the compartment below the seat to access the battery.
-
Secure the ground wire of the PC6 with the 6mm ring lug to the negative terminal of the bike’s battery
-
Route the PC6 wiring harness forward towards the engine following alongside the stock wiring harness beneath the left side frame rail.
-
Locate and unplug the stock sub-harness connector for the bike’s Fuel Injectors.
This is a BLACK 10-pin connector located just beneath the left side frame rail above the engine.
-
Plug the PC6 connectors in-line of the stock wiring harness
-
Reinstall the compartment above the battery.
-
Using the supplied Velcro, secure the PC6 module inside of this compartment.
Clean both surfaces with the supplied alcohol swab prior to applying the Velcro adhesive. -
Reinstall the fuel tank, the bodywork, and the seat.
Download the latest map fi les from our web site at dynojet.com/tunes.
To see a video of this installation, visit our channel (DynojetResearch) on
YouTube.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>