Dynojet PC6-23003 vPower Commander 6 Husqvarna Installation Guide
- October 27, 2023
- Dynojet
Table of Contents
Dynojet PC6-23003 vPower Commander 6 Husqvarna
INPUT ACCESSORY GUIDE
OPTIONAL ACCESSORY INPUTS
Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps.
You can switch on the fl y between these two base maps when you hook up a
switch to the MAP inputs. You can use any open/close type switch. The polarity
of the wires is not important.
Shifter (Input 1 or 2) Used for clutch-less full-throttle upshifts.
Insert the wires from the Dynojet quick shifter into either Input 1 or Input
2. The polarity of the wires is not important. Set to Input 2 by default.
Speed If your application has a speed sensor then you can tap into the
signal side of the sensor and run a wire into this input. This will allow you
to calculate gear position in the Control Center Software. Once gear position
is set up you can alter your map based on gear position and setup gear-
dependent kill times when using a quick shifter.
Analog This input is for a 0-5v signal such as engine temp, boost, etc.
Once this input is established you can alter your fuel curve based on this
input in the Power Core software.
Launch You can connect a wire to either Input 1 or Input 2 and then the
other end to a switch. This switch when engaged (continuity) will only allow
the RPM to be raised to a certain limit (set in the software). When released,
you will have full RPM.
WIRE CONNECTIONS
To input wires into the PC6 fi first remove the rubber plug on the backside of
the unit and loosen the screw for the corresponding input. Using a 22-24 gauge
wire, strip about 10mm from its end. Push the wire into the hole of the PC6
until it stops and then tightens the screw. Make sure to reinstall the rubber
plug.
NOTE: If you tin the wires with solder it will make inserting them
easier.
INSTALLING THE POWER COMMANDER 6
-
Remove the seat.
-
Remove the fuel tank.
-
Using the supplied Velcro, attach the PC6 to the inner side of the right-hand side cover.
Make sure to clean both surfaces with the supplied alcohol swab before attaching the Velcro. -
Attach the ground wire from the PC6 to the negative side of the battery.
-
Route the PC6 harness towards the throttle body going underneath the frame support.
-
Unplug the stock wiring harness from the fuel injector.
-
Plug the PC6 wiring harness in line with the stock wiring harness and fuel injector.
-
Using the supplied Posi-tap, attach the GREY wire of the PC6 to the stock ORANGE wire of the main wiring harness plugged in at the ECU.
-
This is the 3rd wire from the end, on the top row of the stock ECU connector. Reinstall the fuel tank and the seat.
-
Download the latest map files from our website at dynojet.com/tunes.
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 – 800-992-4993 –DYNOJET.COM © 2008-2021 DYNOJET RESEARCH ALL RIGHTS RESERVED
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>