anslut 018347 Solar Cell Lightning Instruction Manual
- June 4, 2024
- anslut
Table of Contents
anslut 018347 Solar Cell Lightning
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for
future reference. (Translation of the original instructions)
Jula reserves the right to make changes.
For latest version of operating instructions, see
www.jula.com
JULA AB, BOX 363, SE-532 24 SKARA
2021-10-25
© Jula AB
Instructions
SAFETY INSTRUCTIONS
-
Do not expose the battery to naked flames or high temperatures.
-
The lamp and solar panel are weather resistant, but do not immerse them in water or any other liquid.
-
Do not look directly into the lamp when it is switched on.
-
Do not use the lamp if the chimney is damaged.
-
The light sources are not replaceable.
If the lamp stops working it must be discarded. -
Do not attempt to charge batteries with a battery charger that is connected to the mains, and do not attempt to run the solar lamp from the mains.
Rechargeable batteries
IMPORTANT: When replacing batteries – only use rechargeable batteries.
- Always buy the correct size and type of battery intended for this purpose.
- Remove the batteries from the lamp if it is not going to be used for some time.
- Recycle used batteries in accordance with local regulations.
Symbols
Technical data
- Battery 3.2 V 600 mAh Li-ion
- Luminous flux: 100 lm
DESCRIPTION
- Solar panel
- Lamp stand
- Ground spike
ASSEMBLY
- Twist the solar panel onto the lamp stand.
- Put the ground spike in the lamp stand.
USE
NOTE: Before the solar cell lamp can shine at full capacity the solar panel must have charged the battery in direct sunlight for 36 hours.
- Twist the solar panel to release it from the lamp stand.
- Pull off the plastic tab between the battery and the contact plate.
- Put the switch in the ON position.
- Fasten the solar panel on the lamp stand.
- Place the solar lamp so that it is exposed to the sun for at least 36 hours to fully charge the battery.
Positioning
- The position, weather conditions and season affect the length of time that the batteries can power the lamp.
- The batteries will not be fully charged if the solar lamp is placed in the shade, which will result in a shorter lighting-up period and reduce the lifespan of the batteries.
- Do not place solar lamps near sources of light such as street lamps, this can prevent them from lighting up.
MAINTENANCE
- Do not put the solar lamp near places where there is salt, corrosive substances or fertiliser.
- Avoid scratching the surface of the solar panel, and keep it free from dust and debris.
- Wipe the solar lamp with a soft, damp cloth if necessary.
Replacing the battery
- Twist the solar panel to release it from the lamp stand.
- Put the switch in the OFF position.
- Undo the screws holding the battery cover.
- Lift off the battery cover.
- Remove the old battery and insert a new rechargeable battery. Make sure the new battery is properly inserted.
- Put the switch in the ON position.
- Replace the battery cover and fasten it with the screws.
- Fasten the solar panel on the lamp stand.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>