SARIS Bones EX Instruction Manual

: June 6, 2024
: SARIS

Table of Contents

LONG FOR THE RIDE
Specifications: Bones EX
Optional Accessories
RACK ORIENTATION
OPENING RACK
SETTING LEG POSITION
POSITIONING ON VEHICLE
ATTACHING STRAPS
INSTALLING BIKES
INSTALLING BIKES
PRECAUTIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SARIS Bones EX

LONG FOR THE RIDE

Just as no garage is complete without a bicycle, at Saris, we believe no car is complete without a bike rack.

Since setting off on this journey nearly 30 years ago, Saris racks have freed millions of bike-lovers to explore new territory and terrain, take part in group rides, bike pool to races, and commute to and from work.

And we continue to do so in style.

As the all-time #1 best-selling bike rack, Saris Bones® continues to set the standard for excellence in design. Today all Saris bicycle racks are intuitive to load and secure, and guaranteed for life.

Built by cyclists for cyclists in Madison, Wisconsin, we strive to create the world’s best bike racks.

Because cycling is what we live for.

MADE IN USA

3-bike shown 3

Specifications: Bones EX

1.800.783.7257
http://www.saris.com/en/vehicle-racks.html

Optional Accessories

Bike Beam is required if bicycle wheels are not parallel to the ground when carrying a bicycle with a sloped top tube, or a full suspension bicycle. Bike Beam is also required if bicycle wheels are 12” or less from the ground when installed on the rack.

RACK ORIENTATION

Bones EX can be configured for different vehicle types, as shown.

OPENING RACK

Turn knob on rack arm counterclockwise to loosen rack arm. Slide arm to center of aluminum tube and open arms as shown, slide arm back over aluminum tube spline. Tighten knob by turning clockwise.

SETTING LEG POSITION

Turn knob counterclockwise on outer leg knob to loosen leg as shown. Remove leg from spline and reinstall on spline at desired position. Refer to page 6 to determine optimal rack orientation. Tighten knob.

POSITIONING ON VEHICLE

Place lower rack feet on bumper. Some vehicles require the feet to be on the trunk lid, refer to saris.com fi t guide for proper feet placement on your vehicle. Place upper feet in center of trunk lid or center of rear window. Raise rack arms as shown. Note: bike cradles furthest from vehicle should be highest from the ground.

ATTACHING STRAPS

Install rack hooks in locations as shown. Hooks are labeled upper, side and lower. Upper hook straps can route through channels in upper legs. Reference fit guide on saris.com for recommended upper leg strap position.

INSTALLING BIKES

Install bike in rack cradles as shown. Lower anti-sway strap on arm should be positioned at the rear of the bike. Close straps and pull tight. Heaviest bikes should be installed closest to vehicle. Note: be aware of bicycle tire position in relation to vehicle exhaust. Be sure bike tires are at least 12” from ground. Do not open trunk or hatch with rack and/or bikes installed.

PRECAUTIONS

Do not open vehicle trunk or gate when rack is installed.

Technical Specifications 3-Bike
Bike carrier weight: 12lbs/5kg
Permitted load capacity: max 105lbs/48 kg
Max bike weight: 35 lbs/16 kg

Technical Specifications 2-Bike
Bike carrier weight: 12lbs/5kg
Permitted load capacity: max 70lbs/32 kg
Max bike weight: 35 lbs/16 kg

CAUTIONS:

All requirements for compatibility/fit as stated in the current Saris vehicle/carrier compatibility guide must be followed. (Available at any Saris dealer or www.saris.com). If your vehicle is not listed or you have any questions, please call our customer service at 800-783-7257 or visit www.saris.com.
Read and follow instructions carefully. Save owner’s manual for future reference or parts information. Ensure that any other users of the bicycle carrier are familiar with their content.
Drive slowly over speed bumps, 5 to 10 mph max speed.
It’s the end users responsibility to ensure that use of this product meets all local and state laws.
When cleaning vehicle and rack, use only water soluble cleaners. Do not take rack through car wash.
Make sure bike tires are not directly behind exhaust pipe.
Do not mount to any type of trailer or RV including Class B vehicles.
Prior to usage on the road, remove all loose parts from bicycle, including (but not limited to) child seat, basket, lock, light, pump, etc.
This carrier is not recommended for off-road use or for use at speed exceeding 70 mph (113 km/h).
The handling characteristics of a vehicle will change when a rear bicycles carrier is fitted and especially when it is loaded (in particular crosswind sensitivity, handling on bends and braking). Driving techniques should be altered to allow for these changes, reduce speed, especially on bends and allowing for longer braking distances.
The vehicle’s total length increases when the bike carrier is attached. The bikes themselves may increase the vehicle’s total width and height. Take care when reversing and/or entering garages or ferries, etc.
Remove carrier from vehicle when not in use.
This carrier is constructed to carry standard-bike-frames. It is not intended for use with tandem or recumbent bicycles.
Replace any mounting strap at the first sign of wear. Replacement parts are available through your local Saris dealer or call 1-800-783-7257.
Tighten straps regularly during the journey.
Do not exceed maximum load capacity of carrier (105 lbs max or 35 lbs max per bike!) Secure properly and adjust for even load distribution, loading the heaviest/biggest bike first and closest to the vehicle.
The Bike Beam (3037/3040) is recommended if bike wheels are not parallel to the ground or if wheels are less than 12” from the ground.
Saris absolves itself of responsibility for any personal injuries or consequential damage to property or wealth caused by incorrect fitting or use.

Recommended Rack Maintenance & Care Instructions

Each use:

Wipe down trunk rack feet
Avoid ground contact with trunk rack feet
Check straps for signs of wear
Check bike cradles and wheel scoops
Check for loose bolts

Every 90 days actions:

Clean with water and mild soap
Lubricate locks if applicable (use wet, oil-based lubricant; NO WD-40)
Grease hitch bolt threads
Check for scratches in paint.

Official Warranty Terms: Saris Racks
Saris Cycling Group, Inc (SCG), parent company of Saris Racks, warrants our products to the original consumer to be free from defects in materials and workmanship. Your purchase includes the following warranty which is in lieu of all other express warranties. This warranty is extended only to the initial consumer purchaser. This warranty gives you specific legal rights. You may have other legal rights which vary from state to state. Please retain your sales slip for your records, as proof of purchase will be required.

Warranty Term
Car Racks Limited Lifetime
Home Storage/Bike Storage Limited Lifetime
Kool Rack 1 Year
Parking Racks 1 Year

*Warranty only valid for original purchaser. Limited lifetime warranty available in North America only.

Manufacturing defects are most likely to be identified on new products or early in the product’s lifespan. Each warranty claim is unique, and it is solely up to SCG to determine if a product can be covered by the limited lifetime warranty due to defects, or if the product has suffered wear and tear.
Any product or part thereof found to be defective within the term as set forth above will be replaced without charge provided that: (1) its failure resulted from a defect in material or workmanship and not from normal wear and tear expected in the use of the product; (2) the product was not abused, misused, improperly assembled, improperly maintained or damaged by accident or installation of parts or accessories not originally intended or compatible with the racks as originally sold., (3) there was no failure to follow instructions or warnings in Owner’s Manual; (4) no alterations or modifications were made; and (5) the product or part is delivered, freight prepaid, to Saris Cycling Group or an authorized service center.

Please call 1-800-783-7257 to obtain return authorization prior to return. Any other claims not included in the statements above are void and will not be honored. SCG reserves the right to inspect any product before issuing a replacement. SCG’s only obligation shall be to replace such products or parts that it determines are defective.

Limitations
THE FOREGOING WARRANTIES ARE THE ONLY WARRANTIES MADE BY SCG. THERE ARE NO OTHER WARRANTIES. ANY WARRANTY THAT MIGHT OTHERWISE BE IMPLIED BY LAW INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED STRICTLY TO THE APPLICABLE LENGTH OF THIS LIMITED WARRANTY.

SCG shall not be liable for incidental or consequential losses, damages, or expenses in connection with its products. SCG’s liability hereunder is expressly limited to the replacement of goods not complying with this warranty or, at SCG’s election, to the repayment of an amount of the purchase price of the product in question.0

Exclusions

If consumer does not comply with all warnings, cautions, or instructions listed in Instruction Manual, damage is not covered under warranty
Impact/collision damage is not covered under warranty
Cradles and strap damage due to improper arm placement are not covered under warranty
Carrying anything other than a bicycle is not covered under warranty
Paint damage – chipping, cracking, or fading is not covered under warranty
Rust is wear and tear and is preventable with rack maintenance
Weather impact (UV, salt air/water)
Damage to mounting surface
Damage or loss resulting from failure to replace/maintain consumable items not covered.
Not following Recommended Rack Maintenance
Consumable Items not covered by warranty. Including but not limited to.
• Arm and wheel tray adjustment knobs
• Frame and wheel straps
• Vehicle attachment straps
• Molded wheel trays
• Frame cradles
• Threaded assemblies
• Ratcheting assemblies