SARIS 4430 Swing Away Hitch Rack Adapter 2 inch Receiver Instruction Manual

June 6, 2024
SARIS

Swing Away Accessory #4430
Assembly Instructions
Max carrying weight – 250lb/113kg (bikes + rack)
For use with 2” receivers only.
Do not tow with this product – For bike rack use only

Included Items: Accessories include: Tools Needed:

Swing Away x 1
Hitch Tite bracket x1
Hitch bolt x1
Split washer x3| Hitch lock x 1
Keys x 2
Hitch Tightener Clasp U bracket x 1
Hitch Tightener Clasp plate x 1
Flat washer x 3| ****

INSTALLING HITCH

a. Insert Hitch Tite bracket into the end of 2” receiver tube of the Swing Away, as shown.
Line up holes on the Hitch Tite bracket with the holes in the receiver.
b. Install split washer on hitch pin.
c. Insert Swing Away into vehicle’s hitch and line up hitch pin holes.
d. Insert hitch pin into the hitch pin hole on the same side as the Hitch Tite bracket.
e. With a ¾” wrench or socket, tighten the hitch pin securely.
f. Install grey lock head on the end of a hitch pin.

HITCH TIGHTENER INSTALLATION

a. Place Hitch Tightener clasp over the top of the receiver tube of the Swing Away.
b. Install Hitch Tightener clasp plate on the bottom, with the flat side contacting the
vehicle’s hitch and the bent side contacting the Swing Away receiver, as shown.
c. Install flat washer, split washer, then the nut. Tighten both sides evenly.

OPERATING THE SWING AWAY

Opening the Swing Away
a. Install rack to Swing Away as directed by your hitch rack manual.
b. Open the latch handle to unhook the latch from Swing Away, as shown.
c. Pull the lever on top of the Swing Away to release the Swing Away arm and open it.
d. Open Swing Away to fully open position.
*Swing Away will lock in the open position.
Closing the Swing Away
e. Pull the handle at the end of Swing Away to release and close.
f. Place latch clasp over hooks on the lower side of Swing Away and secure handle.
Insert latch safety pin.
g. When the handle is secure there will be no gap between Swing Away receiver lower
tube as shown. If there is a gap the handle is too loose and requires tightening.
If the handle will not close it will need to be loosened. See step 4 for latch adjustment instructions.

ADJUSTING LATCH

a. To adjust the latch, turn the ½” nuts on the latch clasp as shown to desired tightness.
(note: release lever will be more difficult to operate when the rack is loaded)

Notes/Warranty:

  • Do not tow with this product – For bike rack use only.
  • The latch must be tight and closed for transport.
  • Do not step on Swing Away or the attached rack.
  • Check with the hitch rack’s manufacturer to determine if your rack is approved for use on the Saris Swing Away Accessory.
  • Operate Swing Away on a level surface.
  • Do not overload the bike rack, consult your racks instruction manual for maximum allowed bike weights.

Saris hitch rack approved for use:
4025HD SuperClamp HD 2-bike (maximum of 35lb per bike allowed)
4025F SuperClamp EX 2-bike (maximum of 35lb per bike allowed)
4412F Freedom EX 2-bike (maximum of 35lb per bike allowed)
4412B Freedom 2-bike (maximum of 35lb per bike allowed)
4031 MTR 1-bike (maximum of 60lb per bike allowed)
4032 MTR 2-bike (maximum of 60lb per bike allowed)
774 Glide EX 4-bike (maximum of 35lb per bike allowed)

CAUTIONS:

  • All requirements for compatibility/fit as stated in the current Saris vehicle/carrier compatibility guide must be followed. (Available at any Sari’s dealer or www.saris.com). If your vehicle is not listed or you have any questions, please call our customer service at 800-783-7257 or visit www.saris.com.

  • Read and follow instructions carefully. Save owner’s manual for future reference or parts information. Ensure that any other users of the bicycle carrier are familiar with their content.

  • Drive slowly over speed bumps, 5 to 10 mph max speed.

  • It’s the end-users responsibility to ensure that the use of this product meets all local and state laws.

  • When cleaning vehicles and racks, use only water-soluble cleaners. Do not take the rack through a car wash.

  • Make sure bike tires are not directly behind the exhaust pipe.

  • The rack must be installed directly into the vehicle hitch receiver. Do not modify the hitch receiver or use hitch extenders.

  • Do not mount to any type of trailer or RV including Class B vehicles.

  • Prior to usage on the road, remove all loose parts from the bicycle, including (but not limited to) child seat, basket, lock, light, pump, etc.

  • This carrier is not recommended for off-road use or for use at a speed exceeding 70 mph (113 km/h).

  • The handling characteristics of a vehicle will change when a rear bicycles carrier is fitted and especially when it is loaded (in particular crosswind sensitivity, handling on bends, and braking). Driving techniques
    should be altered to allow for these changes, reduce speed, especially on bends, and allow for longer braking distances.

  • The vehicle’s total length increases when the bike carrier is attached. The bikes themselves may increase the vehicle’s total width and height. Take care when reversing and/or entering garages or ferries, etc.

  • Remove carrier from the vehicle when not in use.

  • Tighten straps regularly during the journey.

  • The vehicle should be in good condition in the area in which the hitch is located.

  • Do not exceed the maximum load capacity of the carrier (250 lbs max) Secure properly and adjust for even load distribution, loading the heaviest/biggest bike first and closest to the vehicle.
    • Saris absolves itself of responsibility for any personal injuries or consequential damage to property or wealth caused by incorrect fitting or use.

Warning and Disclaimer:
This carrier has been designed to carry bicycles on specific vehicles. Before installation, the user must read and follow current Saris Fit Guide (available through Sari’s dealer) recommendations and enclosed instructions.
Fit recommendations are based on the vehicle’s standard features; optional features may affect the fit recommendations. User must attach carrier correctly to the vehicle, check its attachment before each use, and inspect carrier
parts for wear. Carrier’s attachment to the vehicle is critical and beyond the control of the manufacturer. Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage, or loss, whether
direct, indirect, or incidental, resulting from the incorrect attachment, improper use, inadequate maintenance, or neglect of this carrier.

OFFICIAL WARRANTY TERMS
Saris Cycling Group, Inc (SCG), the parent company of Saris Racks, warrants our product to the original consumer to be free from defects in materials and workmanship. Please retain your sales slip for your records, as proof of purchase will be required.

WARRANTY TERM
Swing Away: 2 years
Note: No damage to mounting surfaces is covered.
Any product or part thereof found to be defective within the term as set forth above will be replaced without charge provided that: (1) its failure resulted from a defect in material or workmanship and not from normal wear and tear expected in the use of the product; (2) the product was not misused, improperly assembled, improperly maintained or damaged by accident; (3) there was no failure to follow instructions or warnings in Owner’s Manual; (4) no alterations or modifications were made; and (5) the product or part is delivered, freight prepaid, to Saris Cycling Group or an authorized service center. Please call 1-800-783-7257 to obtain a return authorization prior to return. SCG reserves the right to inspect any product before issuing a replacement. SCG’s only obligation shall be to replace such products or parts that it determines are defective.

LIMITATIONS
The foregoing warranties are in lieu of and exclude all other warranties not expressly set forth herein, whether expressed or implied by operation of law or otherwise. Other than as set forth above, SCG makes no warranty, whether express, implied, or statutory, with respect to any product, including, but not limited to, warranties of reliability, merchantability fitness for a particular purpose, or those arising from any course of performance, dealing, usage or trade. SCG shall not be liable for incidental or consequential losses, damages, or expenses in connection with its products. SCG’s liability hereunder is expressly limited to the replacement of goods not complying with this warranty or, at SCG’s election, to the repayment of an amount of the purchase price of the product in question. Some states do not permit the exclusion or limitation of implied warranties or incidental or consequential damages, so the preceding limitations and exclusions may not apply to you.

EXCLUSIONS

  • If the consumer does not heed cautions listed in Instruction Manual, the damage is not covered under warranty
  • Impact/collision damage is not covered under warranty
  • Cradles and strap damage due to improper arm placement are not covered under warranty
  • Carrying anything other than a bicycle is not covered under warranty
  • Rust is wear and tear and is preventable with rack maintenance
  • Weather impact (UV, salt air/water)

RECOMMENDED RACK MAINTENANCE
Each use:

  • Check for loose bolts

Every 90 days actions

  • Clean with water and mild soap
  • Lubricate locks if applicable (use wet, oil-based lubricant; NO WD-40)
  • Grease hitch bolt threads
  • Check for scratches in the paint

Saris 5253 Verona Road Madison
WI 53711 800.783.7257
www.saris.com
31443 09/20

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals