ENFORCER Overhead Door Magnetic Contacts User Manual

: June 6, 2024
: ENFORCER

Table of Contents

Features
Parts List
Installation
Specifications
LIFETIME LIMITED WARRANTY
Customer Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ENFORCER Overhead Door Magnetic Contacts User Manual

Features

Operating voltage: 12~24 VDC
2 3 /4″ (70mm) Gap for overhead doors
Adjustable to fit most door-channel widths
24″ (61cm) Armored wire leads
Reed switch has deactivated rhodium on gold underplating
SM 226LQ For closed-loop circuits
SM-226L-3Q For open or closed-loop circuits
IP66 – Epoxy sealed for weatherproof installation
Mounting bracket included
Limited lifetime warranty

Parts List

1x Contact Switch
1x Magnet with bracket
1x Manua

Installation

Please read the manual carefully before installation

Mount the contact on the floor near the bottom of the door. Ensure that the contact switch is in a safe location away from equipment interference and near where the magnet will be when the door is closed.
Run the armored cable to the side and connect its two wires to two wires from the alarm control panel
Mount the magnet on the roll up door so that it will trigger the contact when the door is closed. Be sure that the gap between the contact and magnet does not exceed 23/4″ (70mm).

Specifications

Model	SM-226LQ	SM-226L-3Q
Loop type	Closed loop	Open/Closed loop
Electrical configuration	N.O. (SPST)	NO/NC/COM (SPDT)
Operation gap	23/4″ (70mm)
Connectors	24″ (61cm) Armored leads

Material

NOTES:

Contact and magnet must be installed on the protected side of the door.
On wood surfaces, the magnet must be
installed at least 1 /4″ (6.4mm) from the switch housing to comply with UL 681 installation requirements

California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

LIFETIME LIMITED WARRANTY

This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be responsible for any costs or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM’s option.
In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited warranty is for products sold and installed in the United States and Canada. For all other countries the warranty is 1 (one) year.

NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2020 SECO-LARM U.S.A., Inc. All rights reserved.