TokeShimi 99W9250 DC Rechargeable Floor Fan User Manual

: June 6, 2024
: TokeShimi

Table of Contents

DC Rechargeable Floor Fan
Technical Data
Important Safety Instructions
Cautions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DC Rechargeable Floor Fan

TokeShimi 99W9250 DC Rechargeable Floor Fan

Please read these instructions carefully before installing and operating the appliance.

Thank you for choosing our Floor Fan. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new fan.

Technical Data

MODEL	SIZE(Inch)	VOLTAGE(V)	FREQUENCY(Hz)	POWER(W	SPEED(RPM)
PD-30	12	90~240	50/60	<45	0-1300

This portable fan has several key features:

Built-in rechargeable lithium battery pack with 5-Watt USB charging port.
Stepless variable speed control.
IPX4 12V DC fan motor.
Steel shroud, wire frame, and carry handle.
Aluminum fan blade.
Charge status and battery level LED indicators.
Adjustable tilt angle.
1300 CFM maximum airflow.
Run time from 4 hours to 20 hours, depending on the selected fan speed.

Your fan battery may require charging before portable use. For best performance, charge the battery fully before operating the fan without the wall charger plugged in.

Fan Speed Adjustment

On the rear of the fan, the fan speed adjustment knob is located on top of the battery pack.
Turn the knob clockwise until you feel a”click”. The indicator LED lights will come on and show the battery level of the fan, and the fan is now on the lowest possible speed.
Adjust the knob clockwise to increase the fan speed, counterclockwise to decrease. Turn the knob counterclockwise completely, past the”click”to turn the fan off.

Tilt Adjustment

Slightly loosen both adjustment knobs by turning counter clockwise.
Adjust fan to the angle you want.
Tighten both adjustment knobs by turning clockwise.

Charging

Plug the wall charger into a standard 120V outlet, and plug the connector into the round charging port on the battery housing. (Make sure the dust cover is removed)
The fan will start charging, and the LED will flash at the approximate nearest battery level percentage (20%, 40%, 60% 80%, 100%). When the battery is completely discharged,the LED may take several minutes to start flashing. The fan can be on or off when charging, but with the fan on during charging, the time to charge the battery fully will increase, depending on fan speed.
When the fan is fully charged and the fan is off, the LED lights will turn off.

Cleaning/Maintenance

WARNING: Unplug the battery charger from the wall and the fan before cleaning.

Use a soft damp cloth to clean. Then wipe with dry cloth.
Do not use a cleaning solution, detergents, or chemicals that are harmful to paints or plastics.
Do not bend the blades.
The motor bearings are permanently sealed and do not require additional ubrication.
If using compressed air to clean, do not direct it into the motor housing or battery housing.
Do not spray the fan with pressurized water.

Outdoor Use

This fan is suitable for outdoor use in good weather conditions only. Place the fan on a flat level surface for best results and avoid placing the fan where it can fall onto a person and cause injury.The IPX4 rating means that the fan can operate when splashed with water from any direction.Direct streams of water, immersion, heavy rain, snow, hail, sleet, frost, extreme heat, heavy winds, dust,sand, mud, and other adverse weather conditions can cause improper operation and damage to the fan. Temperatures below freezing will cause the battery to perform poorly, and in extreme cases not at all. If using an extension cord with this product, the cord should be rated for the power requirements of the charger, or greater. Never use the charger with a damaged extension cord or outlet.

Important Safety Instructions

When using the appliance, you should notice the supply voltage must match the rating voltage shown on the label. (Allowing voltage deviates±5%)
Before the fan works, please check whether the fan blades and the cover grill are installed properly. Make sure the fan blade doesn’t touch the grill, and the clips fix grill well.
Do not use the appliance in explosive, dusty, and vaporous air.
Do not use appliance in the place with temperature 45℃ or higher.
This appliance is not intended for use by person (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for the safety.
Children should be supervised to ensure that they do not play with the appliance.
If the power cord is damaged, it must be replaced by the manufacturer or its service agent, or similar qualified persons, in order to avoid hazard.
To reduce the risk of electric shock, disconnect power before servicing.