DELTA UH4100 Multi Ball Holder Storage Net Instructions
- June 6, 2024
- Delta
Table of Contents
**DELTA UH4100 Multi Ball Holder Storage Net Instructions
**
Assembly instructions
Parts
- A. x1 — Back Plate
- B. x2 — Wire Ends
- C. x1 — Front Plate
- D. x2 — Screws
- E. x1 — Net
Tools Required
Hand Drill 1/8″ (3mm)
Way of locating studs within the wall (see hardware store for advice)
- Identify where wooden stud lies within wall, drill pilot holes for wood screws.
IMPORTANT SAFETY NOTE Beware of drilling into electrical wire or pipes within wall!
Place front plate on the corner of a table/flat surface. Position wire ends face down into slots of front plate Slide under small center plate. (FIGURE 1).
NOTE: Be sure front of wire ends are facing down. Insert back plate on top. Be sure wire ends are covered and fit securely between back and front plates. (FIGURE 2)
BACK VIEW OF PLATES AND WIRE ENDS
WARNING: Do not exceed maximum total weight limit of 4.5kg/10lbs. To
avoid injury, Do not overload.
-
Once assembled, transport to pre-drilled wall location. Secure to wall with both screws.
-
After wall installation, slide net onto each arm.
Assembly video
Visit design by delta.com/downloads
Service
Please do not return to store; for immediate response email
service@designbydelta.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>