delta BH4000 Wheel Hitch Front Wheel Holder Instruction Manual
- October 30, 2023
- Delta
Table of Contents
delta BH4000 Wheel Hitch Front Wheel Holder
Product Information
The Wheel HitchTM Front Wheel Holder is a product designed to hold a front wheel of a bike. It comes with pre-drilled holes that allow for inserting a lock to secure the wheel. It works with 20-29 inch wheels and fits bikes with a 100 mm x 9 mm dropout.
Parts included in the package are:
- A x1 — Wheel Hitch
- B x2 — Bolts
- C x2 — Nuts
Tools required for assembly:
- Allen Key (Included)
IMPORTANT WARNING: The Wheel Hitch is designed to hold a front wheel only and has not been designed to support a rider and should never be used with a person on the bike.
Product Usage Instructions
Follow the below assembly instructions for the Wheel HitchTM Front Wheel Holder:
-
Place the Wheel Hitch in the desired location of a flat surface and mark one hole for drilling.
-
Drill a hole using a 1/4 bit.
IMPORTANT SAFETY NOTE: Wear eye protection when using power tools. -
Insert a 1/4 (6mm) diameter bolt through the hole and tighten it securely using an included nut.
-
Drill the second hole using the Wheel Hitch base as a guide.
-
Insert the second bolt and tighten the nut securely.
-
Place the front tire into the top grooves and secure it by closing the quick-release lever.
If you face any issues with the product, please do not return to the store. Instead, email [email protected] for an immediate response.
Assembly instructions
Service: Please do not return to store; for immediate response email [email protected]
Parts
- x1 — Wheel Hitch
- x2 — Bolts
- x2 — Nuts
Tool Required
- Allen Key (Included)
INSTALLATION INSTRUCTION
-
Place Wheel Hitch in desired location of flat surface and mark one hole for drilling.
-
Drill hole using 1/4″ bit.
IMPORTANT SAFETY NOTE
Wear eye protection when using power tools. -
Insert 1/4″ (6mm) diameter bolt through hole and tighten securely. (Using included nut)
-
Drill second hole using Wheel Hitch base as a guide.
-
Insert second bolt and tighten nut securely.
Works with 20-29 inch wheels Fits bike with a 100 mm x 9 mm dropout
WARNING
The Wheel Hitch is designed to hold a front wheel only and has not been
designed to support a rider and should never be used with a person on the
bike.