RANGER 3310-PC Contoured Partition Installation Guide

RANGER 3310-PC Contoured Partition

REQUIRED ITEMS

• 2x Persons
  

• Cordless Impact

• Cordless Drill

• Knife

• Philips Screw Driver

• Plusnut Tool

• Ratchet

• 1/2″ Socket

• 7/16″ Socket

• 10mm Socket

• 13mm Socket

• T30 Torque Bit

• T40 Torque Bit

• 9/16″ Wrench

• 1/2″ Holesaw

PHASE 1 – ASSEMBLY

SETUP

Unpack components; compare with the bill of materials.

Verify all parts are present.

Item No.

| Description|

Qty.

---|---|---

30-089

| Floor Bracket|

1

30-090

| J – Shape Bracket|

2

30-092

| Lower Panel|

1

70-633

| Mounting Track ( 53-1/4″ L )|

1

79-932

| Warning Label ( Bilingual )|

1

30-0940

| Upper Panel w/ Label|

1

94-3002

| Assembly Fastener Bag|

1

96-3002

| Installation Fastener Bag|

1

Identify the Assembly and Installation fastener bags.

Assembly Fastener Bag

PHASE 1 – ASSEMBLY

PARTITION ASSEMBLY

Attach the lower panel and mounting track to the upper panel.

Attach the sides of the upper panel and lower panel together on both sides.

PHASE 2 – INSTALLATION

TIPS ON HOW TO ATTACH A PLUSNUT

Attach the plusnut using the plusnut gun.
TIPS: Put the plusnut on the plusnut gun, then attach the plusnut in the hole by turning the gun forward until the plusnut locks, then remove the gun by turning in reverse.

Attach the plusnut using the 6490 plusnut tool.
NOTE: The hardware used for the 6490 plusnut tool is not included in the fastener bag.

TOOLS

• Cordless Impact
• 7/16″ Socket
• 9/16″ Wrench

TIPS STEP 1:
Assemble the 6490 plusnut tool with the hardware needed, plusnut and the 9/16″ wrench as shown.

TIPS STEP 2:
Attach the plusnut in the hole by turning the bolt forward using an impact with a 7/16″ socket until the plusnut locks, then remove the bolt by turning the impact in reverse.

PHASE 2 – INSTALLATION

VEHICLE PREPARATION

Removing handle.
NOTE: If you are installing a Composite Partition and your Promaster City is supplied with an oversized sliding door handle, this handle must be removed in order for the door to close properly.

Removing overhead plastic.
NOTE: There are two types of covers. (White Covers – Without OEM partition, and Black Covers – With OEM partition)

Driver and passenger sides preparation.

Ceiling and floor preparation.

PHASE 2 – INSTALLATION

CONTOURED PARTITION INSTALLATION

Attach J – shapes and the floor brackets in the van.

Lift the assembled partition in the van, then bolt both sides of the partition in the van.

Attach the upper and lower panels to the J – shapes and floor brackets.

Apply the warning label on the upper panel.

For any feedback or suggestions you may have, please contact: cs@rangerdesign.com
For technical support, contact us at 1-800-565-5321

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>