RANGER DESIGN 6550-FTS Shelving Track Kit Installation Guide
- October 30, 2023
- RANGER DESIGN
Table of Contents
RANGER DESIGN 6550-FTS Shelving Track Kit
Product Information
The 6550-FTS Install Track Kit is designed for the Ford Transit 130 WB, Driver
Side Medium Roof. The kit includes mounting tracks, end caps, and a customer
fastener kit. The kit requires a cordless impact, cordless drill, 1/4 Plusnut
gun or Plusnut tools, 3/8 drill
bit, 7/16 socket, 13mm socket, tape measure, and marker for installation.
Product Usage Instructions
Phase 1 – Assembly
- Setup: Unpack components and compare with the bill of materials provided in the user manual. Verify all parts are present.
Phase 2 – Installation
- Mounting Track Installation: Attach one end cap on each side of the mounting tracks. Use the OEM threaded holes on the vehicle to mount the tracks using Plusnuts and the fasteners provided in the customer fastener kit. Refer to the diagram provided in the user manual for proper placement of Plusnuts.
- New Shelving Installation w/ Install Track
Kit: Align the wall brackets to the wall mounting track kits, then install the wall brackets to the wall mounting track kits using channel nuts. Tighten the bolts that used to attach the wall bracket to the wall or wall kits first before tightening the bolts that used to attach the wall bracket to the end panel.
After installation is completed, ensure all bolts are tightened properly. For technical support or feedback/suggestions, contact Ranger Design at 1-800-565-5321 or email cs@rangerdesign.com.
REQUIRED ITEMS
- Cordless Impact
- Cordless Drill
- 1/4″ Plusnut Gun or Plusnut Tools
- 3/8″ Drill Bit
- 7/16″ Socket
- 13mm Socket
- Tape Measure
- Marker
PHASE 1 – ASSEMBLY
SETUP
Unpack components; compare with the bill of materials.
Verify all parts are present
BILL OF MATERIALS
Item No. | Description | Qty. |
---|---|---|
70 – 612 | Mounting Track 56.5″ | 2 |
70 – 611 | Mounting Track 47.5″ | 2 |
10 – 557 | End Cap | 8 |
96 – 6025 | Customer Fastener Kit | 1 |
Fastener kits
FOR SHELVING INSTALL
PHASE 2 – INSTALLATION
MOUNTING TARCK INSTALLATION
Attach one end cap on each side of the mounting tracks
- Place the mounting tracks in the van, then mark the holes that need to used to van.
- Attach plusnut to the van, then install the mounting track.
TOP REAR
PHASE 2 – INSTALLATION
NEW SHELVING INSTALLATION W/ INSTALL TRACK KIT
Aligned the wall brackets to the wall mounting track kits, then install the wall brackets to the wall mounting track kits using channel nuts.
NOTE: Tightened the bolts that used to attach the wall bracket to the wall or wall kits 1st before the bolts that used to attach the wall bracket to the end panel.
IMPORTANT : After installation is completed, ensure all bolts are tightened.
“You have successfully installed your
6550-FTS
Thank you for doing business with us.”
For any feedback or suggestions you may have, please contact:
cs@rangerdesign.com
For technical support, contact us at 1-800-565-5321
6550-FTS Installation Guide | REV. C2
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>