DELTA 52001 Series Adjustable Slide Bar/Grab Bar 2-Setting Hand Shower Installation Guide
- June 6, 2024
- Delta
Table of Contents
77538
Models
52001, 52002, 52003 & 52008
Series
Parts and Hardware included:
1 – Wall Slide Bar with adjustable ADA Slide Mechanism
1 – Full Spray Hand Shower with Rub Clean and Dual Check Valves
1 – 60” UltraFlex®Hose or 69” Double Spiral Hose
1 – Set of Mounting Hardware Six (6) #10 x 2-1/2” Wood Screws
INSTALLATION INSTRUCTIONS FOR ADA WALL SLIDE BAR & HAND SHOWER SYSTEM
Tools Needed for Installation:
- Slot-headed screwdriver
- Electric drill
- 5/32” drill bit
- Soft cloth
- Wrench or pliers
WARNING
SLIDE BAR MAY NOT PROVIDE A DESIGNED AMOUNT OF SUPPORT UNLESS THESE
INSTALLATION INSTRUCTIONS ARE STRICTLY FOLLOWED.
For proper installation, both ends of the Slide Bar MUST be installed into a
wall stud. For solid support, at least two (2) of the three (3) screws on each
end of the
Slide Bar MUST go through the wallboard or tile and be tightly secured into
the wall stud. Given standard stud sizes, only two (2) of the three (3) screws
may
screw into the wall stud.
Slide Bar may be installed vertically, horizontally, or at an angle, so long
as at least two (2) of the three (3) mounting screws on each end of the Slide
Bar is secured into a wall stud. Locate the wall studs behind the wall before
beginning installation (a stud finder can be obtained from a hardware store).
** WARNING
THE FOLLOWING STEPS REQUIRE DRILLING INTO THE WALL.
When drilling into the wall, exercise care to avoid any electrical wiring or
plumbing that may be located behind the wall. Damaged electrical wiring can
cause electrical shock and/or fire. Since older homes do not always fall in
line with current housing codes and requirements, know where internal wall
wiring is located so that no wires will interfere with your installation.
PROPER INSTALLATION IS EXTREMELY IMPORTANT. IF IN DOUBT, INSTALLATION
SHOULD BE DONE BY A QUALIFIED PROFESSIONAL.**
USING SLIDE BAR:
- Read, understand, and follow the information in the SAFETY WARNINGSsection of this instruction Sheet. Delta Faucet shall have no liability for any damage or injury caused by improper installation or use of this Slide Bar.
- Grasp the Slide Bar when exiting or entering the bathtub or shower.
- Use EXTREME caution on the wet tub or floor surfaces.
- DO NOT put entire weight on Slide Bar. Slide Bar is rated for persons weighing up to 300 pounds when properly installed.
- DO NOT stand, sit or step on Slide Bar. DO NOT use Slide Bar as a stupor platform to reach the area above the tub. Use the bar for assistance ONLY.
CARE AND MAINTENANCE:
- Use of mild soap and water or a non-abrasive cleaner is recommended for cleaning.
- Periodically inspect the Slide Bar for damage or looseness. DO NOT use if any damage or looseness exists. Contact your authorized dealer for assistance.
- SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
1. BEFORE INSTALLING SLIDE BAR:
-
Remove the Slide Bar and parts from the package. If concealed mount Slide Bar is used, move cover plates away from mounting holes.
-
Determine where you want to install the Slide Bar.
-
Place Slide Bar on the wall at the desired position. If mounting horizontally or vertically, check that the Slide Bar is level.
-
With a pencil, mark the centers of the mounting hole positions on one end. These are the points where you will later drill pilot holes for putting in the
-
Repeat Step 4 for the other end of the Slide Bar.
TO INSTALL INTO WOOD WALL STUDS: -
Put on safety glasses before starting.
-
Use the 3/8” power drill and 5/32” drill bit to drill all holes into the wall and wood wall studs at the marked positions. NOTE: If installing Slide Bar over ceramic tiles, the 1/4” carbide tip drill bit will be needed for drilling through the tile, in order to prevent damage to the tiles. Drill pilot holes through the tiles by using a 1/4” carbide tip drill bit. Once a hole has been drilled through the ceramic tiles, use the 5/32” drill bit to drill a pilot hole in the wood wall stud itself.
-
Place Slide Bar on the wall, aligning mounting holes with the holes in the wall.
-
Insert the wood screws provided into one end of the Slide Bar. Screw into wall and wall stud (HAND tightens ONLY). Wood Wall Stud
-
Repeat Step 4 for the opposite end of the Slide Bar.
-
Securely tighten all mounting wood screws with a screwdriver.
-
If concealed mount Slide Bar is used, move cover plates over mounting holes and firmly press against the wall.
2. Prior to snapping the two cover flanges in place, make certain the Wall Slide Bar is installed securely. Then snap the two cover flanges into place, pressing tightly so the three catches on each wall flange lock into position.
3. Install Mount/Slide Bracket. Reference Mount/Slide Bracket instruction installation (separate Sheet).
4. For installation with an existing showerhead , remove the showerhead by turning counter-clockwise with an adjustable wrench or pliers. Be careful not to unscrew the shower arm – hold the shower arm secure while unscrewing the showerhead. Note: If the existing shower arm has an integral ball connector, replace it with a standard, 1/2” threaded shower arm.
5. Wrap the shower arm threads with plumber tape before installing them into plumbing fitting. Hand tightens hose end to shower arm (or water supply) by turning clockwise. Then fully tighten with an adjustable wrench or pliers. Use a soft cloth between the jaws of the tool and the hose connector to protect the finish.
6. Carefully tighten another end of the hose to the hand shower. Place the hose from the hand shower into the holder (or bracket) section of the arm mount and slip down. Do not force. The hose takes a “natural drape” after warm water has been run through it.
7. The arm mount unit (for the hand shower) of the Wall Slide Bar can be adjusted (7A) by pushing up or down on the extended Paddle to move the unit up or down (on vertical or angled Slide Bar installations) and left or right (on horizontal installation). After positioning as desired, flip the Paddle into the straight (locked in) position. In addition, (7B) the arm mount can be adjusted by lightly tapping on the base of the arm mount unit.
8. The arm mount unit also can be twisted clockwise or counterclockwise for the desired positioning for the hand shower.
9. Additional adjustments of the arm mount unit are available with the
holder section of the arm mount unit. This holder can be turned clockwise or
counter-clockwise for the desired mounting of the hand shower.
Note: This “water saver” shower is designed to limit water usage to 2.5
gallons per minute maximum. A flow control disc is pre-installed at the end of
the handle where the handle attaches the hose. The hand shower also contains
dual check valves for backflow protection.
10. Do not force the handle in or out of the arm mount unit. The
hand shower is easily removed from the arm mount by lifting the handle upward.
Cleaning Instructions
To clean the hand shower faceplate: Remove the shower handle from the hose. Soak the hand shower in a 50/50 solution of white vinegar and water for 30 minutes to dissolve mineral buildup. Reassemble; do not overtighten the handle to the hose. Turn on the shower to wash the impurities out of the
hand shower. To clean the Wall Slide Bar or Arm Mount Unit : Wipe with a soft, damp cloth – do not use detergent or cleansers that may be harmful to the finish.
Limited Warranty on Delta® Faucets
Parts and Finish. All parts (other than electronic parts and batteries) and finishes of Delta® faucets purchased from authorized Delta sellers are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed. For commercial purchasers, (a) the warranty period is ten (10) years for multi-family residential applications and (b) five (5) years for all other commercial applications, in each case from the date of original purchase. For purposes of t is the warranty, the term “multi-family residential application” refers to the purchase of the faucet from an authorized Delta seller by a purchaser who owns but does not live in the residential dwelling in which the faucet is initially installed, such as in a rented or leased single unit or multi-unit detached home (duplex or townhome), or a condominium, apartment building or community living center. The following installations are not considered multi- family residential applications, are excluded from the 10-year warranty, and are subject to the 5-year warranty: industrial, institutional, or other business premises, such as a dormitory, hospitality premises (hotel, motel, or extended stay location), airport, educational facility, long- or short-term healthcare facility (hospital, rehabilitation center, nursing, assisted or staged-care living unit), public space or common area.
Parts and Finish for Delta® Recertified Faucets. Delta Faucet Company offers for sale on deltafaucet.com Delta® Recertified faucets. All parts (other than electronic parts and batteries) and finishes of these Delta® Recertified faucets are warranted to the original consumer purchaser to be free from defects in material and workmanship for ten (10) years from the date of original purchase. For commercial purchasers, the warranty period is one (1) year from the date of the original purchase.
Electronic Parts. Electronic parts (other than batteries), if any, of Delta® faucets purchased from deltafaucet.com or authorized Delta sellers are warranted to the original consumer purchaser to be free from defects in material and workmanship for five (5) years from the date of original purchase or, for commercial purchasers, for one (1) year from the date of original purchase. No warranty is provided on batteries.
What We Will Do. Delta Faucet Company will repair or replace, free of charge, during the applicable warranty period (as described above), any part or finish that proves defective in material and/or workmanship under normal installation, use, and service. If repair or replacement is not practical, Delta Faucet Company may elect to refund the purchase price in exchange for the return of the product. These are your exclusive remedies
What Is Not Covered. Because Delta Faucet Company is unable to control
the quality of Delta products sold by unauthorized sellers, unless otherwise
prohibited by law, this warranty does not cover Delta products purchased from
unauthorized sellers.
Any labor charges incurred by the purchaser to repair, replace, install or
remove this product are not covered by this warranty. Delta Faucet Company
shall not be liable for any damage to the faucet resulting from reasonable
wear and tear, outdoor use, misuse (including use of the product for an
unintended application), freezing water, abuse, neglect or improper or
incorrectly performed installation, maintenance or repair, including failure
to follow the applicable care and cleaning instructions. Delta Faucet Company
recommends using a professional plumber for all installation and repair of
faucets. We also recommend that you use only genuine Delta® replacement parts
What You Must Do To Obtain Warranty Service or Replacement Parts. A warranty claim may be made and replacement parts may be obtained by calling 1 800 345 DELTA (3358) or by contacting us by mail or online as follows (please include your model number and date of original purchase):
In the United States and Mexico: | In Canada: |
---|---|
Delta Faucet Company | Masco Canada Limited, Plumbing Group |
Product Service | Technical Service Centre |
55 E. 111th Street | 350 South Edgeware Road |
Indianapolis, IN 46280 | St. Thomas, Ontario, Canada N5P 4L1 |
Attention: Customer Solutions | Attention: Customer Service |
www.deltafaucet.com/service-parts/contact-us| http://www.deltafaucet.ca/customersupport/assistance.html
Proof of purchase (original sales receipt) from the original purchaser must be made available to Delta Faucet Company for all warranty claims unless the purchaser has registered the product with Delta Faucet Company or the product is a Delta® Recertified product purchased from deltafaucet.com. This warranty applies only to Delta® faucets manufactured after January 1, 2019, and installed in the United States of America, Canada, and Mexico.
Limitation on Duration of Implied Warranties. Please note that some
states/provinces (including Quebec) do not allow limitations on how long an
implied warranty lasts, so the below limitations may not apply to you. TO THE
MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, ANY IMPLIED WARRANTY, INCLUDING
THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR
PURPOSE, IS LIMITED TO THE STATUTORY PERIOD OR THE DURATION OF THIS WARRANTY,
WHICHEVER IS SHORTER.
Limitation of Special, Incidental, or Consequential Damages. Please note
that some states/provinces (including Quebec) do not allow the exclusion or
limitation of special, incidental, or consequential damages, so the below
limitations and exclusions may not apply to you. TO THE MAXIMUM EXTENT
PERMITTED BY APPLICABLE LAW, THIS WARRANTY DOES NOT COVER, AND DELTA FAUCET
COMPANY SHALL NOT BE LIABLE FOR, ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES (INCLUDING LABOR CHARGES TO REPAIR, REPLACE, INSTALL OR REMOVE THIS
PRODUCT), WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED WARRANTY,
BREACH OF CONTRACT, TORT, OR OTHERWISE. DELTA FAUCET COMPANY SHALL NOT BE
LIABLE FOR ANY DAMAGE TO THE FAUCET RESULTING FROM REASONABLE WEAR AND TEAR,
OUTDOOR USE, MISUSE (INCLUDING USE OF THE PRODUCT FOR AN UNINTENDED
APPLICATION), FREEZING WATER, ABUSE, NEGLECT, OR IMPROPER OR INCORRECTLY
PERFORMED INSTALLATION, MAINTENANCE, OR REPAIR, INCLUDING FAILURE TO FOLLOW
THE APPLICABLE INSTALLATION, CARE AND CLEANING INSTRUCTIONS. Notice to
residents of the State of New Jersey: The provisions of this warranty,
including its limitations, are © 2015 Masco Corporation of Indiana intended to
apply to the fullest extent permitted by the laws of the State of New Jersey.
Additional Rights. This warranty gives you specific legal rights, and you may
also have other rights which vary from state/province to state/ province.
This is Delta Faucet Company’s exclusive written warranty and the warranty is
not transferable.
If you have any questions or concerns regarding our warranty, please contact
us as provided above or view our Warranty FAQs at
www.deltafaucet.com.
77538 Rev. C
© 2020 Delta Faucet Company
Documents / Resources
|
DELTA 52001 Series Adjustable Slide Bar/Grab Bar 2-Setting Hand
Shower
[pdf] Installation Guide
52001 Series, 52002 Series, 52003 Series, 52008 Series, Adjustable Slide Bar
2-Setting Hand Shower, Adjustable Grab Bar 2-Setting Hand Shower
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>