LucidSound LS15X Wireless Surround Sound Gaming Headset User Guide
- June 6, 2024
- LucidSound
Table of Contents
LS15X
WIRELESS
GAMING HEADSET
USER GUIDE
Headset
Accessories
Microphone
Setup
!!! IMPORTANT !!!
To complete setup for Xbox and enable Surround Sound go to:
Support
DONGLE MODEL NO : LS50XTX
FCC ID : 2AGZW06430 IC : 21203-06430
HEADSET MODEL NO : LS15X RX
FCC ID : YFK-1520233AA IC : 9246A-1520233AA
MANUFACTURER : BENSUSSEN DEUTSCH & ASSOCIATES, LLC (BDA, LLC) 15525
WOODINVILLE-REDMOND RD. NE WOODINVILLE, WA 98072
RF FREQUENCY : 2.40335 GHz TO 2.47935 GHz
OUTPUT POWER : TX = 5.83dBm RX = 1.5dBm
INPUT POWER : DC 3.7V, 1050mAh
MADE IN CHINA
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for Class B digital devices, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment. (Example – use only shielded
interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
CAN ICES-3(B)/NMB-3(B)
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference;
- This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled environment.
BATTERY WARNING
Do not attempt to replace the rechargeable battery yourself- you may damage
the battery, which could cause overheating, fire, and injury. The Lithium-ion
battery in your device should be serviced or recycled by PowerA or an
authorized provider and must be recycled or disposed of separately from
household waste. Dispose of batteries according to
your local environmental laws and guidelines.
Do not use or leave the product containing rechargeable batteries exposed to
very high temperatures (e.g. at strong direct sunlight or in a vehicle in
extremely hot weather). Otherwise, it can overheat, catch fire or the
performance will degenerate, and the service life will be shortened.
Do not use the rechargeable battery item in a location where static
electricity is rich, otherwise, the internal safety devices may be damaged,
causing a harmful situation.
In case the electrolyte gets into the eyes due to the leakage of the battery,
do not rub your eyes! Rinse eyes with clean running water and seek medical
attention immediately. Otherwise, it may injure the eyes or cause a loss of
sight.
If the battery gives off an odor, generates heat, or in any way appears
abnormal during use, recharging, or storage, immediately remove from the
battery charger and place it in a sealed vessel such as a metal box.
Be aware discarded batteries may cause fire, do not heat the product or throw
it into the fire.
EU DECLARATION OF CONFORMITY
Hereby, Bensussen Deutsch & Associates LLC at 15525 Woodinville-Redmond Road NE, Woodinville, WA 98072 USA is marketing this device under the brand name LucidSound and declares that this wireless headset is in compliance with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: LucidSound.com/EUDOC
WEEE (Waste Electrical and Electronic Equipment Directive
If you eventually want to dispose of this product at a later time, please
observe the following instructions: Electronic equipment should not be
disposed of together with household waste. Please recycle the device if the
appropriate recycling ways are available to you. Please contact your local
authority or retailer and ask them for advice on
recycling.
RoHS
This product has been certified as RoHS compliant in accordance with Directive
2011/65/CE.
USA and worldwide : One-year limited warranty
Europe : Two-year limited warranty For warranty details or support with
your LucidSound products, please visit LucidSound.com/warranty
Australia
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a 1-year replacement warranty in which you
are entitled to
have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
What you must do:
If a defect has appeared within 90 days from the date of purchase, the product
may be returned to the retailer for a replacement.
If a defect has appeared after 90 days from the date of purchase, you must
initiate a repair by following the online repair process at
www.LucidSound.com.au.
Once all details are completed, you will receive a return authorization number. Then, label and ship your LucidSound headset – including the return authorization (RA) number, freight prepaid, to LucidSound’s authorized repair center.
LucidSound
c/o Tec works International Pty Ltd
Unit 1 / 12 Tollis Place
Seven Hills NSW 2141
Please ensure the return authorization (RA) number is prominently displayed on the outside of your packaging. The cost incurred to return the product to the retailer or to the authorized repair center as part of a Warranty claim is your responsibility.
What we will do:
During the Warranty Period, we will, at our option, repair or replace the
product or any defective parts. We will also bear the reasonable costs of
standard return shipping. If this cannot be done, then we will refund the
purchase price to you.
AU wholesale distributor:
Level 2, 2 Darling Street South Yarra, Australia VIC 3141 | bluemouth.com.au |
+61 (3) 9867 2666 Email:
support@bluemouth.com.au
© 2020 Bensussen Deutsch & Associates, LLC. LucidSound, the LucidSound logo,
PowerA, and the PowerA logo are trademarks of Bensussen Deutsch & Associates,
LLC.
Microsoft, Xbox, Xbox “Sphere” Design, Xbox Series X|S, Xbox One, Windows, and Windows Sonic are trademarks of the Microsoft group of companies.
The shape and design of this product are a trade dress of Lucid Sound, its subsidiaries, and affiliates. All rights reserved. All other product names and images are trademarks or registered trademarks of their respective owners. Product features, appearance, and specifications may be subject to change without notice. Please retain this information for future reference. Made in China.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>