LucidSound LS15P Wireless Gaming Headset User Guide

: June 6, 2024
: LucidSound

Table of Contents

Headset
Accessories
Microphone
PlayStation Setup
PC Setup
Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LS15P
WIRELESS
GAMING HEADSET
USER GUIDE

Headset

Accessories

Microphone

PlayStation Setup

!!! IMPORTANT !!!
To complete setup for PS4/PS5 go to:

https://bit.ly/2Q23any

PC Setup

!!! IMPORTANT !!!
To complete setup for PC go to:

https://bit.ly/2FzrET1

Support

DONGLE MODEL NO : LS15P TX
FCC ID: YFK-1520233AB IC : 9246A-1520233AB
HEADSET MODEL NO : LS15P RX
FCC ID : YFK-1520233AA IC : 9246A-1520233AA
MANUFACTURER : BENSUSSEN DEUTSCH & ASSOCIATES, LLC (BDA, LLC) 15525 WOODINVILLE-REDMOND RD. NE WOODINVILLE, WA 98072

RF FREQUENCY : 2.40335 GHz TO 2.47935 GHz
OUTPUT POWER : TX = 4dBm RX = 1.5dBm
INPUT POWER : DC 3.7V, 1050mAh
MADE IN CHINA
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.

FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example – use only shielded interface cables when connecting to computer or peripheral devices).

FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

CAN ICES-3(B)/NMB-3(B)
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference;
2. This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled environment.

BATTERY WARNING
Do not attempt to replace the rechargeable battery yourself- you may damage the battery, which could cause overheating, fire, and injury. The Lithium-ion battery in your device should be serviced or recycled by PowerA or an authorized provider and must be recycled disposed of separately from household waste. Dispose of batteries according to your local environmental laws and guidelines.
Do not use or leave the product containing rechargeable batteries exposed to very high temperatures (e.g. at strong direct sunlight or in a vehicle in extremely hot weather). Otherwise, it can overheat, catch fire or the performance will degenerate, and the service life will be shortened.
Do not use the rechargeable battery item in a location where static electricity is rich, otherwise, the internal safety devices may be damaged, causing a harmful situation.
In case the electrolyte gets into the eyes due to the leakage of the battery, do not rub your eyes! Rinse eyes with clean running water and seek medical attention immediately. Otherwise, it may injure the eyes or cause a loss of sight.
If the battery gives off an odor, generates heat, or in any way appears abnormal during use, recharging, or storage, immediately remove it from a battery charger and place it in a sealed vessel such as a metal box.
Be aware discarded batteries may cause fire, do not heat the product or throw it into the fire.

EU DECLARATION OF CONFORMITY

Hereby, Bensussen Deutsch & Associates LLC at 15525 Woodinville-Redmond Road NE, Woodinville, WA 98072 USA is marketing this device under the brand name LucidSound and declares that this wireless headset is in compliance with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: LucidSound.com/EUDOC

WEEE (Waste Electrical and Electronic Equipment Directive
If you eventually want to dispose of this product at a later time, please observe the following instructions: Electronic equipment should not be disposed of together with household waste. Please recycle the device if the appropriate recycling ways are available to you. Please contact your local authority or retailer and ask them for advice on recycling.

RoHS
This product has been certified as RoHS compliant in accordance with Directive 2011/65/CE.

USA and worldwide : One-year limited warranty
Europe : Two-year limited warranty
For warranty details or support with your LucidSound products, please visit LucidSound.com/warranty

Australia
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a 1-year replacement warranty in which you are entitled to
have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

What you must do :
If a defect has appeared within 90 days from the date of purchase, the product may be returned to the retailer for a replacement.
If a defect has appeared after 90 days from the date of purchase, you must initiate a repair by following the online repair process at www.LucidSound.com.au.

Once all details are completed, you will receive a return authorization number. Then, label and ship your LucidSound headset – including the return authorization (RA) number, freight prepaid, to LucidSound’s authorized repair center.

LucidSound
c/o Tec works International Pty Ltd
Unit 1 / 12 Tollis Place
Seven Hills NSW 2141

Please ensure the return authorization (RA) number is prominently displayed on the outside of your packaging. The cost incurred to return the product to the retailer or to the authorized repair center as part of a Warranty claim is your responsibility.

What we will do :
During the Warranty Period, we will, at our option, repair or replace the product or any defective parts. We will also bear the reasonable costs of standard return shipping. If this
cannot be done, then we will refund the purchase price to you.

AU wholesale distributor :
Level 2, 2 Darling Street South Yarra, Australia VIC 3141 | bluemouth.com.au | +61 (3) 9867 2666 Email: support@bluemouth.com.au

The shape and design of this product are a trade dress of Lucid Sound, its subsidiaries, and affiliates. All rights reserved. All other product names and images are trademarks or registered trademarks of their respective owners. Product features, appearance, and specifications may be subject to change without notice. Please retain this information for future reference. Made in China.