LucidSound LS15X Wireless Gaming Headset User Guide

: June 5, 2024
: LucidSound

Table of Contents

Headset
Accessories
Microphone
Setup
Support
- FCC STATEMENT
- EU DECLARATION OF CONFORMITY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LucidSound LS15X Wireless Gaming Headset User Guide

Headset

Left Side Description

Volume Wheel
Center Button
Audio Mute
(Press and hold for 3 seconds to check battery level)
Power/Charging LED Port
- Solid = On/Connected/Charged
- Slow Blink = Not connected
- Pulsing = Charging

Right Side Description

Game/Chat Balance
Mic Monitoring
Mic Monitor On/Off = Press and hold for 3 seconds
Mic Mute
Mute/Unmute = Short Press
LED on Boom Mic illuminates when muted
EQ Button
Press and release to cycle through EQ presets.

Accessories

Boom Mic
Micro USB Charge Cable
USB Wireless Transmitter

Microphone

Setup

Product Setup

!!! IMPORTANT !!!

To complete setup for Xbox and enable Surround Sound go to:

https://bit.ly/3iIM9ek

Support

DONGLE MODEL NO: LS50XTX
FCC ID: 2AGZW06430 IC: 21203-06430
HEADSET MODEL NO: LS15X RX
FCC ID: YFK-1520233AA IC: 9246A-1520233AA
MANUFACTURER: BENSUSSEN DEUTSCH& ASSOCIATES, INC.
(BDA, LLC)15525 WOODINVILLE-REDMOND RD. NE WOODINVILLE, WA 98072

RF FREQUENCY: 2.40335 GHz TO 2.47935 GHz
OUTPUT POWER: TX = 5.83dBm RX = 1.5dBm
INPUT POWER: DC 3.7V, 1050mAh
MADE IN CHINA

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.

FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example – use only shielded interface cables when connecting to computer or peripheral devices).

FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

CAN ICES-3(B)/NMB-3(B)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

This device may not cause interference;
This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled environment.

BATTERY WARNING

Do not attempt to replace the rechargeable battery yourself- you may damage the battery, which could cause overheating, fire, and injury. The Lithium-ion battery in your device should be serviced or recycled by PowerA or an authorized provider and must be recycled or disposed of separately from household waste. Dispose of batteries according to your local environment laws and guidelines.

Do not use or leave the product containing rechargeable batteries exposed to very high temperature (e.g. at strong direct sunlight or in a vehicle in extremely hot weather). Otherwise, it can overheat, catch fire, or the performance will degenerate, and the service life will be shortened.

Do not use the rechargeable battery item in a location where static electricity is rich, otherwise, the internal safety devices may be damaged, causing a harmful situation.

In case the electrolyte gets into the eyes due to the leakage of battery, do not rub eyes! Rinse eyes with clean running water and seek medical attention immediately. Otherwise, it may injure eyes or cause a loss of sight.

If the battery gives off an odor, generates heat, or in any way appears abnormal during use, recharging or storage, immediately remove it from battery charger and place it in a sealed vessel such as a metal box.

Be aware discarded batteries may cause fire, do not heat the product or throw it into fire.

EU DECLARATION OF CONFORMITY

Hereby, Bensussen Deutsch & Associates LLC at 15525 Woodinville Redmond Road NE, Woodinville, WA 98072 USA is marketing this device under the brand name LucidSound and declares that this wireless headset is in compliance with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: LucidSound.com/EUDOC

WEEE (Waste Electrical and Electronic Equipment Directive
If you eventually want to dispose of this product at a later time, please observe the following instructions: Electronic equipment should not be disposed of together with household waste. Please recycle the device if the appropriate recycling ways are available to you. Please contact your local authority or retailer and ask them for advice on recycling.

RoHS
This product has been certified as RoHS compliant in accordance with Directive 2011/65/CE.

USA and worldwide: One year limited warranty
Europe: Two year limited warranty
For warranty details or support with your LucidSound products, please visit LucidSound.com/warranty

Australia
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a 1 year replacement warranty in which you are entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

What you must do:
If a defect has appeared within 90 days from the date of purchase, the product may be returned to the retailer for a replacement.

If a defect has appeared after 90 days from the date of purchase, you must initiate a repair by following the online repair process at www.LucidSound.com.au.

Once all details are completed, you will receive a return authorisation number. Then, label and ship your LucidSound headset – including the return authorisation (RA) number, freight prepaid, to LucidSound’s authorised repair centre.

LucidSound
c/o Tecworks International Pty Ltd
Unit 1 / 12 Tollis Place
Seven Hills NSW 2141

Please ensure the return authorisation (RA) number is prominently displayed on the outside of your packaging. The cost incurred to return the product to the retailer or to the authorised repair centre as part of a Warranty claim are your responsibility.

What we will do:
During the Warranty Period, we will, at our option, repair or replace the product or any defective parts. We will also bear the reasonable costs of standard return shipping. If this cannot be done, then we will refund the purchase price to you.

AU wholesale distributor:
Level 2, 2 Darling Street South Yarra, Australia VIC 3141 | bluemouth.com.au
+61 (3) 9867 2666
Email: support@bluemouth.com.au

Microsoft, Xbox, Xbox “Sphere” Design, Xbox Series X, Xbox One, Windows, and Windows Sonic are trademarks of the Microsoft group of companies.

The shape and design of this product are a trade dress of Lucid Sound, its subsidiaries and affiliates. All rights reserved. All other product names and images are trademarks or registered trademarks of their respective owners. Product features, appearance and specifications may be subject to change without notice. Please retain this information for future reference. Made in China.

Logo