ADLER AD7427 Electric Hot Water Bottle Warmer User Manual
- June 6, 2024
- ADLER
Table of Contents
ADLER AD7427 Electric Hot Water Bottle Warmer
WARNING
PLEASE READ CAREFULLY. IMPORTANT INSTRUCTIONS, KEEP FOR LATER USE.
IMPORTANT INSTRUCTIONS
-
Read the operating manual before using the device and follow the instructions contained in it. The manufacturer is not liable for damage caused by using the device against its intended use or improper handling.
-
The device is for domestic use only. Do not use for other purposes that are not in accordance with its intended use.
-
Connect the device only to a 230 V ~ 50/60 Hz earthed socket. In order to increase the safety of use, do not switch on many electrical devices simultaneously to one circuit.
-
Be extra cautious when using the device when children are nearby. Do not allow children to play with the device, do not let children or persons not familiar with the device use it. The equipment should not be used by young children, unless the controllers have been pre-set by parents or guardians, or children have been thoroughly instructed how to safely handle the regulators.
Children under three years of age cannot use this device due to the lack of response to overheating. -
WARNING: This equipment may be used by children over 8 years of age and persons with limited physical, sensory or mental abilities, or persons who have no experience or knowledge of the equipment, if this is done under the supervision of a person responsible for their safety or given to them. tips on the safe use of the device and are aware of the dangers associated with its use. Children should not play with the equipment. Cleaning and maintenance of the device should not be performed by children unless they are over 8 years of age and are supervised. This device cannot be used by people who are not heat sensitive, and people who are very sensitive to heat, who are unable to respond to overheating and by people who require constant care.
-
Always after use, remove the plug from the socket by holding the socket with your hand. DO NOT pull on the power cord.
-
Do not immerse the cable, plug and the entire device in water or other liquid. Do not expose the device to atmospheric conditions (rain, sun, etc.) or do not use in conditions of high humidity (bathrooms, damp camping houses).
-
Periodically check the condition of the power cord. If the power cord is damaged, it should be replaced by a specialist repair facility in order to avoid a hazard.
-
Do not use the device with a damaged power cord or the device is not working properly. Do not repair the device yourself, as it may cause shock. Please return the defective device to the appropriate service center for inspection or repair. All repairs may only be carried out by authorized service points. Incorrectly performed repair can cause serious danger to the user.
-
Do not use the device near flammable materials.
-
Do not leave the device or the adapter connected to the outlet unattended.
-
To provide additional protection, it is advisable to install a residual current device (RCD) with a rated residual current not exceeding 30 mA in the electrical circuit. In this regard, please contact an electrician.
-
Do not allow the device or adapter to get wet. If the device falls into the water, immediately pull the plug or adapter from the power socket. Do not put your hands into water when the device is connected to the mains. Before re-use, it must be checked by a qualified electrician.
-
Do not handle the device or adapter with wet hands.
-
The device should be turned off every time you put it down.
-
Do not use the device near water, for example: in the shower, in the bathtub or above the basin with water.
-
If the device uses a power supply, do not cover it, as it could lead to a dangerous increase in temperature and damage to the device. Always, first insert the plug into the power socket in the device and then the power supply to the mains socket.
-
Do not put pins, needles and other metal objects in the device.
-
Check the equipment periodically for signs of wear or damage. If such signs or equipment are used improperly, please contact your supplier before continuing to use it.
-
Store in a dry place. Never put heavy objects on it.
-
Never go to sleep with the device turned on. Unplug the power plug from the outlet.
-
Before switching on the electric sheet, make sure that it is evenly distributed, there are no kinks or folds.
-
The product cover can be washed in the washing machine in 30°C temperature.
-
Do not iron.
-
This equipment is not intended for medical use in hospitals.
-
The device should cool down before storage.
-
The device may be used only with the types of removable elements specified in the equipment marking.
-
The device is equipped with a fuse protecting against overheating, which should not work when used in accordance with the intended use of the equipment. If the fuse trips, the device will stop working, the equipment must be returned to the manufacturer or its representative for repair.
Device Description
1. Device
2. Charger
3. Power cable
4. Cover
5. Indicator Light
How to use it?
- Before charging this warmer(1), please put the warmer and charging rack(2) flat on the table with the plug upward, then insert the charging rack(2) on the warmer and connect the power.
- The warmer will automatically cut off and the indicating light (5) will turn off after 10-15 minutes of heating. Then please pull out the charging rack, the warmer can be used freely without the charging rack.
- When the warmer is cool, you may recharge again.
Waning
1. Do not use when charging.
2. Do not charge on a incline or upright.
3. Charge on a flat surface only.
To clean the cover (4) hand wash in max 30C hot water. Do not use bleach.
SPECIFICATIONS
Voltage: 220-240V ~ 50Hz Power: 360 W
To protect your environment: please separate carton boxes and plastic bags and dispose of them in corresponding waste bins. The used appliances should be delivered to the dedicated collecting points due to hazardous components, which may affect the environment. Do not dispose of this appliance in the common waste bin.