Chacon 34033 Alarm with Motion Sensor User Manual

Chacon 34033 Alarm with Motion Sensor

Box Content

Registering your warranty

To register your warranty, fill in the online form at www.chacon.com/warranty

introduction

Thank you for using this product.

• Please read the instructions carefully before using the device.
• Do not attempt to dismantle or repair the product yourself as it will invalidate the warranty.

Introduction to the product

1. Infrared
2. Movement detector
3. Red light
4. Green light
5. Siren 2
6. Activation / deactivation button

Note: This item comes with six AG13 batteries to power the two remote controls included in the kit.

Battery installation: Alarm control unit with motion detector

1. Open the battery compartment cover on the back of the control unit.
2. Insert 4 “AA” batteries in the battery compartment, paying attention to the polarity symbols+ and-.
3. Close the cover of the control unit.

Note: If the alarm sounds too weak, please replace the batteries.

Battery installation: infra-red remote control

1. Remove the cover at the back by unscrewing the screws.
2. Insert the three batteries received in the battery compartment, taking care to observe the polarity symbols+ and-.
3. Close the cover of the remote control.

Note: If the indicator light on the control no longer lights up or becomes dim when you press the button, please replace the batteries.

Wall lnstallatlon of the central unit
When choosing the location of the central unit, always ensure that the installation height is 2 meters from the ground and slightly inclined forwards. The foot for fixing the central unit and the screws are supplied.
Warning: Do not place the control unit against a heat source. Choose a place where it can be hung without risk of being exposed to direct sunlight, rain or strong luminosity.

Device synchronization
After the batteries have been inserted in the control unit, as well as in the two remote controls, you have to do press the button on the remote controls once. The main unit will then emit a “beep” to let you know that the alarm is now armed.

How it works

The alarm with motion detector is immediately ready for use once you have inserted the batteries. Thanks to the remote controls supplied, you can arm and disarm the control unit remotely. Each time you press the button on the control unit, the red indicator on the remote control will light up.

Monitoring mode

1. To activate or deactivate the central unit, simply aim the central unit with the remote control to the infrared receiver which is located in the back of the red plate.
2. lf the green light comes on, it means that you have armed your central unit.
3. When the central unit is in surveillance status, it will detect anything within a perimeter of 5m, with a field of vision of up to 110°.

Note: If the control unit detects movement, the red LED will flash. Within 10 seconds, if nobody presses the button on the remote control, the alarm of the central unit will be triggered. After about 45 seconds, the sound will stop and the main unit will return to the monitoring mode.
Only the remote control can disarm the central unit.

Safety tips

• Do not mix new and used batteries.
• Please only use the battery type indicated in the manual.
• Do not leave used batteries in the unit, as this may damage the unit.
• Do not place the unit against a heat source, where it could be exposed to direct sunlight, rain or strong luminosity.
• The central unit is not water resistant. Do not expose it to rain or immerse it in water.
• Do not attempt to disassemble or repair the product yourself.
• Please keep these operating instructions in a safe place.
• Incorrect use of the battery can damage nearby objects and risk fire or serious injury.
• Please keep batteries away from children.
• Recycle used batteries in accordance with environmental practices.

Specifications

• Can be switched on or off remotely via the supplied controls
• Easy to install
• The central unit can be hung on the wall or placed on a table.
• Scanning range: 5 m (free field)
• Angle of coverage: 110°.
• Alarm volume: 105 dB
• Indoor use
• Transfo. 6V-200mA (not included)
• Sensor battery: 4x AA 1.5 V (not included)
• Remote control battery (2x): 3x AG13 (included)
• Contents: alarm with motion sensor+ 2 remote controls+ battery remote control (2x) + manual

RECYCLING
In accordance with European WEEE directives (2002/96/EC) and directives concerning accumulators {2006/ 66/EC), any electrical or electronic device or accumulator must be collected separately by a local system specialising in the collection of such waste. Do not dispose of these products with ordinary waste. Check the regulations In force. The logo shaped like a waste bin Indicates that this product must not be disposed of with household waste in any EU country.
To prevent any risk to the environment or human health due to uncontrolled scrapping, recycle the product in a responsible manner. This wI promote the sustainable use of material resources. To return your used device, use the return and collection systems, or contact the original dealer. The dealer will recycle it in accordance with regulatory provisions.

For indoor use only

Support
www.chacon.com/support

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>