ADLER AD 1286 Kettle Glass User Manual
- June 6, 2024
- ADLER
Table of Contents
AD 1286
user manual
SAFETY CONDITIONS IMPORTANT INSTRUCTIONS ON SAFETY OF USE PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
The warranty conditions are different if the device is used for commercial purposes.”
-
Before using the product please read carefully and always comply with the following instructions. The manufacturer is not responsible for any damages due to any misuse.
-
The product is only to be used indoors. Do not use the product for any purpose that is not compatible with its application.
-
The applicable voltage is 220-240V, ~50/60Hz. For safety reasons, it is not appropriate to connect multiple devices to one power outlet.
-
Please be cautious when using around children. Do not let the children play with the product. Do not let children or people who do not know the device use it without
supervision. -
WARNING: This device may be used by children over 8 years of age and persons with reduced physical, sensory or mental capabilities, or persons without experience or
knowledge of the device, only under the supervision of a person responsible for their safety, or if they were instructed on the safe use of the device and are aware of the dangers associated with its operation. Children should not play with the device. Cleaning and maintenance of the device should not be carried out by children unless they are over 8 years of age and these activities are carried out under supervision. -
After you are finished using the product always remember to gently remove the plug from the power outlet holding the outlet with your hand. Never pull the power cable!!!
-
Never put the power cable, the plug, or the whole device into the water. Never expose the product to atmospheric conditions such as direct sunlight or rain, etc. Never use the product in humid conditions.
-
Periodically check the power cable condition. If the power cable is damaged the product should be turned to a professional service location to be replaced in order to avoid
hazardous situations. -
Never use the product with a damaged power cable or if it was dropped or damaged in any other way or if it does not work properly. Do not try to repair the defective product yourself because it can lead to electric shock. Always turn the damaged device to a professional service location in order to repair it. All the repairs can be done only by authorized service professionals. The repair that was done incorrectly can cause hazardous situations for the user.
-
Never put the product on or close to the hot or warm surfaces or the kitchen appliances like the electric oven or gas burner.
-
Never use the product close to combustibles.
-
Do not let the cord hang over the edge of a counter or touch hot surfaces.
-
Never leave the product connected to the power source without supervision. Even when use is interrupted for a short time, turn it off from the network, unplug the power.
-
In order to provide additional protection, it is recommended to install a residue current device (RCD) in the power circuit, with a residual current rating of not more than 30 mA. Contact a professional electrician in this matter.
-
If the kettle is overfilled it may spurt boiling water.
-
WARNING: Do not open the lid if the water is boiling.
-
The kettle must only be used with the provided base.
-
CAUTION: Before lifting the kettle from the base make sure that the kettle is turned off.
-
This equipment is intended for domestic and similar use, such as staff kitchens in stores, offices, and other work environments, utility rooms, by customers in hotels, motels, and other residential environments of this type, in bedrooms, and dining rooms.
-
Always use caution when boiling water in the kettle. Do not touch the housing of the kettle or lid. Do not open the lid during boiling in a kettle or immediately after boiling, because steam coming out of the lid can cause burns.
-
Move the kettle only by holding it by the handle.
-
Never fill kettle above MAX level and below MIN level. It may cause damage to the kettle.
-
Never switch on a kettle without water.
-
Never use the kettle without a filter or with an open cover (automatic shutdown will not work).
-
Descale your kettle regularly. Using a kettle with a heating element covered by scale may cause damage.
-
Do not use aggressive detergents to wash the kettle housing – they can damage the kettle or remove the markings.
-
The device is not designed to work with external schedulers or separate remote control systems.
-
Do not wash the base of the kettle directly in the water, just wipe with a dry cloth.
-
Children aged 3 to 8 years old can enable and disable the device only when it is in its normal position of use, they are supervised or instructed on the safe use and understand the resulting risks. Children aged 3 to 8 years old can not connect devices, operate, clean, or maintain.
DESCRIPTION
| 1 – housing | 2 – ON / OFF switch | 3 – indicator lamp |
|---|---|---|
| 4 – rotating base | 5 – the lid | 6 – handle |
USING THE ELECTRIC KETTLE
BEFORE FIRST USE: Fill up the kettle with water, boil and pour. Repeat three times. To remove the possible scent of the manufactory, please boil a few times water.
- Fill the kettle with water. Make sure that the heating plate is fully immersed in water.
- Place the appliance on the flat, even, and heat-resistant surface.
- Plug the kettle to the 220-240~50/60Hz mains, press the ON/OFF switch. An indicator lamp will light.
- After boiling water the kettle will automatically switch off.
- Before taking the kettle out of the base make sure it is switched off.
- The kettle can manually be switched off at any time by the ON/OFF switch.
- Keep the lid closed during the boiling process. Or the kettle won’t automatically switch off.
- After boiling, the time demanded the thermostat to be ready in 2 minutes. After this time kettle can be switched on again.
- Regularly remove limestone sediment inside the kettle. Sediment may cause overheating of the kettle, shorten the life cycle and cancel the guarantee. Use mixings available in household stores or apply citric acid.
- Switching an empty kettle, or with an insufficient level of water, will cause automated switching of the kettle. Wait till cool down the kettle, pour enough water, and after a few minutes switch the kettle on.
- The kettle is an electrical device and it is not designed to hold water or other liquids. After boiling, the water must be immediately poured into another bowl. The water in the kettle after boiling can not stay longer than 10 minutes. Before each use, fill the kettle with fresh water above the minimum and below the maximum level.
CLEANING OF MAINTENANCE
Regularly descale the kettle. Descaling doesn’t belong to guarantee service. Lack of regular descaling causes the damage of the elements of the appliance and cancels the warranty of the product. Use descaling mixture to descale the kettle.
TECHNICAL DATA:
Capacity max: 2,0 L
Voltage: 220-240V ~50/60Hz
Power: 1850-2200W
To protect your environment: please separate carton boxes and plastic bags and dispose of them in corresponding waste bins. The used appliance should be delivered to the dedicated collecting points due to hazardous components, which may affect the environment. Do not dispose of this appliance in the common waste bin.
WARRANTY CARD
WARRANTY CONDITIONS are valid in the territory of the Republic of Poland
Adler Sp. z o.o. ul. Ordona 2a 01-237 Warsaw provides the User with good
quality equipment for which this warranty card is issued and provides a
24-month warranty, which is counted from the date of purchase hardware.
Warranty services are provided upon presentation of a correctly completed
warranty card. Disadvantages or damage to the equipment revealed during the
warranty period will be repaired free of charge by the Central Service. If the
equipment is purchased by an entrepreneur (VAT invoice), the warranty period
is 12 months. The above provision does not apply to sole proprietorships, as
long as the type of equipment purchased does not is related to the business
profile – verification in CEIDG. In the case of replacing the item with a new
one, or after a major repair, the warranty period starts anew from the moment
of delivering the item to the customer free of defects or returning the
repaired item. If the guarantor replaced part of the item, the above provision
shall apply mutatis mutandis to the replaced part. Guarantor undertakes to
cover the costs of delivering the items to the service to the address
indicated in the warranty card. However, the warranty holder should exercise
common sense in choosing the means of transport. Eligible the warranty does
not entitle the guarantor to reimbursement of the costs of delivering the
goods – items for warranty repair, in excess of economically justified costs
of carriage.
NOTE: The equipment is intended for domestic use only. Warranty repairs
are not covered activities related to descaling, maintenance, and cleaning of
the device as well as parts and accessories subject to wear with normal use.
The warranty does not cover mechanical damage to the equipment as well as
defects and damage resulting from:
– improper or inconsistent with the instructions for use, storage, and
maintenance;
– intervention of an unauthorized service, unauthorized repairs, alterations,
and design changes;
-use of improper consumables.
-mechanical, thermal, chemical, and network damage.
– the warranty card is invalid without the date of purchase, the seal of the
seller, and a copy of the purchase document.
– the warranty does not cover consumables and accessories, including glass
elements (e.g. jugs, plates), connection and mains cords, light bulbs,
batteries, knives and foils for cutting devices, mixing attachments, beaters,
mixers, suction brushes, pipes, hoses, mixing cups, cutting heads, and sieves.
The advertised equipment is delivered to the Central Service by the Customer
in a complete condition and properly secured for transport. After the repair,
the defective equipment is collected from Central Service by the Customer.
The deadline for removing the defect may be extended by the time needed to
import the necessary parts, no longer than 30 business days. In any such case,
the service workshop will notify the customer of the extension of the warranty
repair date. Due to the necessity to bring spare parts, he will inform about
the new deadline for removing the defect.
In the event of a defect, it should be reported to the point of sale or the
Central Service, ul. Ordon 2A, 01-237 Warsaw, tel. 728-595-006 or e-mail:
serwis@adler.com.pl.
In the notification, please provide your address, telephone number, and a
description of the defect. It is necessary to attach a copy to the complaint
purchase document.
The warranty does not exclude or limit and does not suspend the rights of the
buyer resulting from the provisions on the warranty for defects in the sold
item.
CENTRAL SERVICE
01-237 Warszawa ul.Ordona 2A
tel. 728 – 595 – 006
www.adler.com.pl
serwis@adler.com.pl
(sale date)
(stamp of the shop and signature of the seller)
| 
| 
---|---|---
Documents / Resources
|
ADLER AD 1286 Kettle
Glass
[pdf] User Manual
AD 1286, Kettle Glass
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>