VISUAL COMFORT TOB 1002 Bryant Floor Lamp Instruction Manual
- June 6, 2024
- VISUAL COMFORT
Table of Contents
ASSEMBLY INSTRUCTIONS
Bryant Floor Lamp
Item # TOB 1002
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Scissors
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Install harp (C) by squeezing together and inserting into top of the saddle (D).
-
Remove finial (A) from harp (C).
-
Remove shade (B) from packaging and install to harp (C) using finial (A).
NOTE: If the shade has additional packaging, carefully cut off from the interior of the shade to avoid damages. -
Install the light bulb into the socket.
-
To adjust fixture height loosen the adjustment knob (E), pull up or down to the desired position then tighten.
NOTE : Help guide cord in or out of base for easier adjusting. -
Remove protective cover (G) from plug (F).
-
Plug into the electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
