AMP Lighting ASPL-3028-X-XX Low Voltage Landscape Lighting Instruction Manual

: June 6, 2024
: AMP Lighting

Table of Contents

Important Safety Instructions: Read Before Installation
Important Safety Instructions
Package Contents
Parts Required
Product Dimensions
Test Solar Light
Install Riser
Install Stake
Install Riser to Stake
How to Replace Battery
Support
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AMP Lighting ASPL-3028-X-XX Low Voltage Landscape Lighting Instruction Manual

Important Safety Instructions: Read Before Installation

This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.

These instructions do not intend to cover all variations in installation, operation maintenance or mounting situations.

Please note that these solar fixtures are equipped with built-in photocells, so they will not turn on until it is dark enough. These fixtures will also require plenty of sunlight to function properly. It’s best to have the fixture in an area where the sun will get to it at all times throughout the day and where no ambient lighting will affect the photocell at night. If your fixture is not functioning at night, be sure that the on/off button has been engaged. See step one for details.

Important Safety Instructions

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

Lamp gets HOT quickly!
Do not touch the hot lens, guard or enclosure.
Keep lamp away from materials that may burn.
Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
Do not operate the luminaire fitting with a missing or damaged shield.

SAVE THESE INSTRUCTIONS

Package Contents

Fixture Body

Parts Required

Riser
Mounting Accessory

Product Dimensions

Test Solar Light

Slide the ON/OFF switch of the fixture to the “ON” position.
Cover solar panels completely by using black materials. The fixture will light up when the solar panel is covered and turn back off when it is uncovered.

Now you can proceed to next steps of installations knowing the fixture is in ON mode.

Install Riser

Thread the riser onto the fixture and hand tighten until snug.

Install Stake

Determine the desired location for mounting the stake mount.
Hammer the stake into the ground until flange of stake is flush to grade. To avoid damage to the stake, place a board on top of the stake while hammering.

Note: If the ground is hard and the stake is difficult to install, make a crosscut in the ground using a flat shovel.

Install Riser to Stake

Thread the riser on to the stake and hand tighten until snug.

How to Replace Battery

Remove Shield

Press the sides of the shield to remove it from the fixture body.

Remove Luminaire

Using a screwdriver, remove the 3 screws.
Then take the light source out of the hat.

Remove Circuit Board

Remove the battery cover from the luminaire by using a screwdriver and removing the screws.

Remove Circuit Board

Disconnect the quick connector by pressing the tabs on the side. Remove the old battery by removing the two screws. Replace the battery and secure it with the previously removed screws. Then connect the tabs of the quick connector back together.

Reinstall the solar panel to the fixture body and secure with previously removed screws.