Porta Phone EPAKM Full Duplex 2.4 GHz Transceiver User Manual
- June 6, 2024
- PORTA PHONE
Table of Contents
Porta Phone EPAKM Full Duplex 2.4 GHz Transceiver
Power ON/OFF
Power ON: Press and hold the power button till to GREEN LED blinking or light up. Power OFF: Press and hold the power button till to the RED LED flashing.
Pairing (Register mode)
a). Press and hold the power button to turn headset power ON, the power
LED should blinking in Green color.
b). Enter the pairing mode: Press the volume down button at 3 times
continually, then press and hold the volume up till to the RED and Green LED
blinking at alternately.
c). Master enter the pairing mode first then also the Remote to pairing
mode. d). The Green LED of Remote headset will several blink fastly then
turn off after paired, press the power button to quit the pairing mode, keep
the Master on the pairing mode then can pair with more Remote or press the
power button to quit the pairing mode.
e). Repeat the above step “d” for more Remote headset paired with the
same Master, or press the power button to finish the pairing(register). (
Note: . The Master headset can accept maximum 8 remotes register in full
duplex, or all the remotes fixed on listening mode, total register number over
250 headset available on listening mode.
Talking and listening
a). The master and remote headset will start to search each other after
power ON, the GREEN LED flash 1 time each 3 seconds. The headset will be link
together automatically when the pairing ID confirmed by master and LED turn ON
in GREEN color.
b). Press the volume up and down button to adjust external wired/wireless
headset speaker sound volume.
Pair with Bluetooth headset
Press the 
button to turn Bluetooth mode ON, then the Bluetooth module will search and
connected to the Bluetooth headset closing to the E-PAK automatically.
Mic Muted
Master: Press the Mic button to MUTE the microphone and press again to
back the normal talking.
Remote: The remote can fixed on NORMAL mode or LISTENING mode by
programing.
Normal mode: Press the Mic button to MUTE the microphone and press again
to back the normal talking.
Listening mode: Microphone non-function, the E-PAK can be listening only
if selected the listening mode.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment has been tested SAR and complies with FCC radiation exposure limits set forth for an uncontrolled environment.
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
IC Radiation Exposure Statement
This equipment has been tested SAR and complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
To prevent possible hearing damage, do not listen at high volume levels for
long periods
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>