SOYAL AR-888 Series Proximity Controller Reader and Keypad Instruction Manual

: June 6, 2024
: SOYAL

Table of Contents

Contents
FCC Statement (part15.21,15.105)
Installation
Flush-Mounted Series
- Basic Commands
- Wiring Diagrams
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SOYAL AR-888 Series Proximity Controller Reader and Keypad Instruction Manual

FCC Statement (part15.21,15.105)

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

（FCC part 15.19）：This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Installation

Installation
Cable selection: Use AWG 22-24 Shielded
Twist Pair to avoid star wiring. Use CAT5 for TCP/IP connection.

Take off two Iron bars from the of bottom body A and and mounting plate B. Pull the cables from the square holes of the eva foam gasket and mounting plate.
Use a screwdriver to screw the eva foam gasket C and mounting plate B onto the wall with Flat Head Cap Philips Tapping Screws (Excluded, the Installer should prepare before installation. The screws shall not be screwed too tight, or it could lead to the deformation of the mounting plate.
Connect the cables to the backside of body A and attach A to B . To fix A on B by inserting two Iron bars from the bottom of A + B.
Attach the Back Cover D to A. Use the Allen key and screws to assemble the Back Cover onto the body.
Hands-off and clear any objects around the 888 (H/K). Turn on the power and LED will light-up and beep will sound. Wait the Touch IC start for 10 sec. to operate.