HOME Sherway 49 in. Double Vanity Instruction Manual

: June 7, 2024
: home

Table of Contents

HOME Sherway 49 in. Double Vanity
Safety Information
WARRANTY
California and Minnesota Residents
Pre-Assembly
TOOLS REQUIRED
PACKAGE CONTENTS
Assembly
Maintenance
Care and Cleaning
Troubleshooting
Documents / Resources

HOME Sherway 49 in. Double Vanity

Product

Safety Information

DANGER

Keep small parts away from children during assembly.
Failure to follow warnings and cautions could result in serious injury.
Product is designed to hold 50 lbs. Exceeding this limit may damage the product or cause injury to the user.
Do not use harsh bathroom cleaners or grout cleaners on any natural stone.

WARNING

Read these instructions carefully and keep in a safe place.
Adult assembly required.
This product should only be used on a flat, level surface.
Do not over tighten connectors (screws, bolts, etc.) Overtightening can lead to product damage.
Small parts may present choking hazard prior to assembly.
Do not stand, step or climb on unit.

CAUTION

USE preventative cleaning measures to keep your stone pristine.
USE sealers according to the product specific directions.
Blot spills quickly, and wash with mild soap and warm water.
Stone countertops (Granite, Marble, etc.) are surprisingly resilient to stains and scratches. However, as a preventative measure, any spills on the stone surfaces should be wiped up within a reasonable amount of time. Do not let liquid sit on the stone overnight. Stones are most prone to staining by oil and acid, so be sure to blot these spills up as soon as they happen. Follow up by cleaning the stone with a mild non-abrasive soap and water.
Be sure to check all packing materials carefully for small parts that may have come loose inside the carton during shipment. If parts are missing, contact THE HOME DEPOT to obtain any missing parts.
Using abrasive cleansers will damage the surface.

WARRANTY

LIMITED LIFETIME WARRANTY

WHAT IS COVERED

Home Decorators Collection products are manufactured with superior quality standards and workmanship and are backed by our limited lifetime warranty. Home Decorators Collection products are warranted to the original consumer purchaser to be free of defects in materials or workmanship. We will replace FREE OF CHARGE any product or parts that proves defective. Simply, return the product / part to any of The Home Depot retail locations or call 1-800-998-7021 to receive the replacement item. Proof of purchase (original sales receipt) from the original consumer purchaser must be made available for all Home Decorators Collection warranty claims.

WHAT IS NOT COVERED

This warranty excludes incidental/consequential damages and failures due to misuse, abuse or normal wear and tear. This warranty excludes all industrial, commercial & business usage, whose purchasers are hereby extended a five-year limited warranty from the date of purchase, with all other terms of this warranty applying except the duration of warranty. Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights that vary from state to state and province to province. Please see a store or contact 1-800-998-7021 for more details.

California and Minnesota Residents

MINNESOTA RESIDENTS
“IMPORTANT HEALTH NOTICE.

SOME OF THE BUILDING MATERIALS USED IN THIS HOME (OR THESE BUILDING MATERIALS) EMIT FORMALDEHYDE. EYE, NOSE, AND THROAT IRRITATION, HEADACHE, NAUSEA AND A VARIETY OF ASTHMA-LIKE SYMPTOMS, INCLUDING SHORTNESS OF BREATH, HAVE BEEN REPORTED AS A RESULT OF FORMALDEHYDE EXPOSURE. ELDERLY PERSONS AND YOUNG CHILDREN, AS WELL AS ANYONE WITH A HISTORY OF ASTHMA, ALLERGIES, OR LUNG PROBLEMS, MAY BE AT GREATER RISK. RESEARCH IS CONTINUING ON THE POSSIBLE LONG- TERM EFFECTS OF EXPOSURE TO FORMALDEHYDE.
REDUCED VENTILATION MAY ALLOW FORMALDEHYDE AND OTHER CONTAMINANTS TO ACCUMULATE IN THE INDOOR AIR. HIGH INDOOR TEMPERATURES AND HUMIDITY RAISE FORMALDEHYDE LEVELS. WHEN A HOME IS TO BE LOCATED IN AREAS SUBJECT TO EXTREME SUMMER TEMPERATURES, AN AIR-CONDITIONING SYSTEM CAN BE USED TO CONTROL INDOOR TEMPERATURE LEVELS. OTHER MEANS OF CONTROLLED MECHANICAL VENTILATION CAN BE USED TO REDUCE LEVELS OF FORMALDEHYDE AND OTHER INDOOR AIR CONTAMINANTS.
IF YOU HAVE ANY QUESTIONS REGARDING THE HEALTH EFFECTS OF FORMALDEHYDE, CONSULT YOUR DOCTOR OR LOCAL HEALTH DEPARTMENT.”

Pre-Assembly

PLANNING ASSEMBLY

To ensure your installation goes smoothly, please read these instructions carefully and review the recommended tools and hardware before you begin.
To remove the old vanity (if applicable):

Turn off the water supply and drain out.
Disconnect the supply lines from the faucet.
Remove the old vanity top and vanity. If the new vanity is not installed immediately, temporarily stuff a rag into the drain pipes.
Using a level locate any uneven floor and/ or wall areas where your vanity will be installed. Unevenness can cause your vanity to become
misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots.

TOOLS REQUIRED

PACKAGE CONTENTS

Part

|

Description

|

Quantity

---|---|---

A

| Vanity with Top|

1

B

| Backsplash|

1

Assembly

Position Vanity
- Place the vanity with top (A) in the desired position taking into account the location of your plumbing.
- Make sure the vanity top is flush against the wall.
- Adjust the leg levelers so the vanity with top (A) is level.
Apply Backsplash Sealant
- Clear backsplash (B) of all debris before applying clear silicon sealant (not included).
- Apply a few thin beads of sealant to unpolished back and bottom edge of the backsplash (B).
Install the Backsplash
- Set unpolished bottom edge of backsplash (B) on the vanity counter top (A) and press gently against wall and down on the top.
- Remove any excess sealant from the wall and the vanity top.

Maintenance

To maintain the beauty of the furniture finish, avoid placing the vanity in direct sunlight.
Avoid exposing the vanity combo to extreme temperatures by installing away from heat and air vents.

Care and Cleaning

Rinse vanity top with clean, hot water frequently.
Blot spills quickly, and wash with mild soap and warm water.
Clean the surface with a glass cleaner or other household cleansers that are non-abrasive
Remove oil-based stains with acetone, mineral spirits, or ammonia.
Organic stains like coffee, tea, or juice can be removed with hydrogen peroxide, mixed with a few drops of ammonia
Water spots or rings can be removed by buffing the spots gently with 00-gauge steel wool.
Small nicks and scratches can often be removed the same way.
Larger scratches, chips, and resilient stains may require professional help. Please contact your local stonemason for details.
Your stone was sealed at the factory, but reapplication is necessary over time. How often is determined by the quality of the sealer used, and the frequency of use. We recommend using a penetrating non-toxic sealer for bath areas.

Troubleshooting

Problem

|

Possible Cause

|

Corrective Action

---|---|---
Vanity doors rub against another surface.|

The floor is not level.

|

Adjust the leg levelers to ensure the vanity combo is level.
Adjust the door hinges.

There is an uneven gap between the doors and cabinet.|

The floor is not level.

|

Adjust the leg levelers to ensure the vanity combo is level.
Adjust the door hinges.

Questions, problems, missing parts? Before returning to the store,
call Home Decorators Collection Customer Service.
8 a.m. – 7 p.m., EST, Monday – Friday, 9 a.m. – 6 p.m., EST, Saturday
1-800-998-7021
HOMEDEPOT.COM/HOMEDECORATORS
Retain this manual for future use.