NEW BRIGHT 21098U-G Remote Control Heavy Metal 4X4 Truck Wrangler Owner’s Manual
- June 6, 2024
- NEW BRIGHT
Table of Contents
OWNER’S MANUAL
Please read and understand all precautions prior to use.
Thank you for choosing a premium New Bright product.
CONTENTS
Component Checklist
- (1) R/C Vehicle With USB Cord
- (1) Transmitter
- (2) AA Batteries
VEHICLE
Features
The ON/OFF Switch controls the main power to the vehicle. To save battery life, always remember to put the switch in the OFF position when not in use.
BATTERY
USB Smart Charge Technology
This product is equipped with USB Smart Charge Technology. The built-in
“smart chip” can recognize the power output level of your chosen USB charging
device. Charge times will vary between charging devices. Charging from a wall
outlet with a USB adapter may be faster than charging from a USB port on a
computer. Using Advanced USB Power Delivery, the smart chip will charge the
vehicle’s internal battery at the fastest speed allowed by your charging
device.
Charging the Vehicle
This vehicle is equipped with an internal Lithium-Ion battery that is
recharged via USB. ON/OFF Switch must be in the OFF position prior to
charging.
-
Locate the ON/OFF switch and USB cord on the underside of the vehicle.
-
Turn the ON/OFF switch to the “OFF’ position.
-
Slide open Storage Compartment cover.
-
Remove the USB cable from the Storage Compartment. (Use care when extending the cord as it is attached to the inside internal battery). The cord can be plugged into any computer or USB outlet adapter (not included).
-
While charging, the LED under the vehicle will be on. Once fully charged the LED will turn off. Charging is completed in approximately 1 – 1.5 hours depending on the type of charging device you use. Return cord and secure storage lid before operating the vehicle.
TRANSMITTER
Features and Functions
FORWARD/REVERSE DRIVING Push BOTH joysticks forward for forwarding Driving.
Pull BOTH joysticks back to drive in Reverse.
360° SPINS — Counter-Clockwise
Push both joysticks in opposite directions continuously as shown for Counter-
Clockwise Spinning.
360° SPINS —
Clockwise Push both joysticks in opposite directions continuously as shown for
Clockwise Spinning.
This transmitter is equipped with 2.4GHz technology which allows up to 6
vehicles to be raced at the same time.
The transmitter will automatically sync with the vehicle.
Batte Installation
- Locate the Transmitter Battery Compartment, which is on the back of the Transmitter.
- Move the Battery Compartment Lock towards the Battery Compartment and remove the Battery Compartment Cover.
- Insert 2 “AA” batteries. Make certain the plus (+) and minus (—) markings on the batteries are in the same position as the plus (+) and minus (—) markings inside the Battery Compartment.
- Replace Battery Compartment Cover making certain that the Battery Compartment Lock has “snapped” into the locked position.
Note: When replacing batteries:
Use alkaline batteries only.
Do not mix old and new batteries.
Do not mix alkaline, standard, or rechargeable batteries.
Precautions and Care
SUPPORT
Troubleshooting & Support
Problem – The vehicle does not move or move slowly.
- Make certain there are fresh batteries in the transmitter and that they have been installed in the correct position.
- Are the (+) and (—) markings on the batteries in the same position as the (+) and (—) markings in the Transmitter Battery Compartment?
- Are the metal contact tabs touching, rusty or dirty in the transmitter?
- Has the rechargeable Internal Battery been fully charged?
- Make certain that the vehicle ON/OFF switch is in the “ON” position.
Problem – Vehicle moves by itself or exhibits reduced range from the transmitter.
- Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines, or tall buildings as possible to ensure no further radio interference will occur.
Always remove Batteries from the transmitter when not in use.
Do not dispose of batteries in a fire. Leakage, explosion, and personal injury
may occur.
Do not attempt jumps or tricks with this vehicle.
Do not attempt to remove the internal battery.
Do not use included USB cord for anything other than its intended purpose.
Always keep a USB cord stored when not in use.
Adult supervision is recommended.
F.C.C. CAUTION:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates. uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
USA & Canada
30-Day Limited Warranty
New Bright Industries warrants to the original purchaser that this product
will be free of defects in materials and workmanship for thirty (30) days from
the date of purchase. In the event of such a defect within the warranty
period, New Bright will repair or replace the product at our sole discretion.
This warranty does not cover damage resulting from unauthorized modifications,
accidents, misuse, or abuse.
Should your item have a defect covered under this warranty? first, call the
toll-free number listed below. Most problems can be resolved in this manner.
If necessary. you will be issued a Return Authorization (RA) number and
instructions on how to obtain a Product Return Form. The Product Return Form
is to be used when returning a product to us (postage pre-paid and insured by
the consumer).
When returning a defective product, please package the product, the Product
Return Form, and a copy of the dated sales receipt as proof of purchase. Be
sure to mark the RA number on the Product Return Form. If the product is
returned without a dated sales receipt, it will be excluded from coverage
under this warranty. Please allow 4 to 6 weeks for delivery of repaired or
replacement vehicles (depending on your location).
New Bright Industries’ liability for defects in materials and workmanship
under this warranty shall be limited to repair or replacement at our sole
discretion. In no event shall we be responsible for incidental, consequential,
or contingent damages (except in those states that do not allow this exclusion
or limitation).
Valid only in the USA & Canada.
Contact New Bright Industries Customer Service Toll-Free at:
1-877-NBI-TOYS
(1-877-624-8697)
Monday through Friday, 8:00 AM to 5:00 PM Eastern Time
U.S. Toy Sales and Marketing Co. Inc.
30260 Oak Creek Drive — 2nd Floor
Wixom MI 48393
1-877-624-8697
http://www.newbright.com/
1EF- PB90216 1202
JN119-21
Documents / Resources
| NEW
BRIGHT 21098U-G Remote Control Heavy Metal 4X4 Truck
Wrangler
[pdf] Owner's Manual
21HHA, G6D21HHA, 21098U-G Remote Control Heavy Metal 4X4 Truck Wrangler,
Remote Control Heavy Metal 4X4 Truck Wrangler
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>