NEW BRIGHT GGH6B TOY Transmitter User Manual

NEW BRIGHT GGH6B TOY Transmitter

Component Checklist

Features And Functions

If the vehicle pulls to the left or right during forward driving the Steering Trim may need to be adjusted. The Steering Trim is located on the bottom of the chassis between the front wheels.

Note: The vehicle has working lights.

• When a vehicle is powered ON, headlights will glow and tail lights will flash for pairing.
• When a vehicle is in motion the headlights and tail lights will glow.

Charging the Battery

This vehicle is equipped with an internal Lithium-lon battery that is recharged via USB. The ON/OFF Switch must be in the OFF position before charging.

1. Locate the ON/OFF switch and USB cord on the underside of the vehicle.
2. Turn the ON/OFF switch to the “OFF” position.
3. Open the Battery Compartment Cover.
4. Remove the USB cable from the Storage Compartment. (Use care when extending the cord as it is attached to the inside internal battery). The cord be plugged into any 5V DC computer or 5V DC USB outlet adapter (not included).
5. While charging, the LED under the vehicle will be on. Once fully charged the LED will turn off. Charging is completed in approximately 2 hours. Return the cord and secure the storage lid before operating the vehicle.

Battery Installation

1. Locate the battery compartment cover on the back of the transmitter. Pull back on the tab in the direction indicated by the arrow.
2. Insert 2 “AA” size batteries. Make sure the positive (+) and negative (-) markings on the batteries match up to the ones inside the Battery Compartment.
3. Replace the Battery Compartment Cover making certain that the Compartment tab has “snapped” into the locked position.

Note:
When replacing Transmitter batteries:

• Do not mix old and new batteries.
• Do not mix alkaline, standard or rechargeable batteries.
• Use alkaline batteries only.

Functions

• This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be raced at the same time.
• Before first use and after any time the batteries are replaced, the transmitter must be paired to the vehicle.

To sync the transmitter and vehicle, follow the steps below:

1. Correctly install batteries in the transmitter.
2. Place the vehicle upside down, and turn the Vehicle ON/OFF switch to the ON position. The Vehicle is only in sync mode for 30 seconds.
3. Immediately pull and hold the Forward/Reverse trigger on the transmitter. Keep holding until the wheels move (up to 30 seconds).

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>