NEW BRIGHT 60877 RC Monster Car User Manual

NEW BRIGHT 60877 RC Monster Car

New Bright

Component Checklist

Vehicle

Features and Functions

• If vehicle pulls to the left or right during forward driving the Wheel Alignment may need to be adjusted. The Wheel Alignment Dial is located on bottom of chassis between the front wheels.

Battery

Charging the Battery

IMPORTANT!
The included 12.8V Lithium Ion battery pack is only PARTIALLY CHARGED prior to shipment and it is recommended the battery be fully charged before first use.
(II]

1. Plug the Charger into a standard indoor electrical outlet.
2. Insert the 12.8V rechargeable battery pack securely into the charger (as shown above). Be sure the arrows are properly matched.
3. Charging Status Light will be solid red while battery is charging. When charging is complete, light will blink green.
4. Charge will last approximately 10-12 minutes depending on terrain and driving style.

IMPORTANT : It is normal for the battery pack to become warm after charging and/or use. Be sure to allow the battery pack to cool before using or recharging. Recharging a warm battery pack will greatly reduce the battery life.
ATTENTION PARENTS

• The Battery Charger & Battery Pack need to be periodically examined for potential hazards. Any potentially hazardous parts need to be repaired or replaced.

Vehicle

Battery Installation

Locate and align arrow on battery pack with arrow inside battery compartment. Place battery pack in battery compartment and slide battery forward in direction of arrow. Once in place, turn locking tab to keep battery pack secure.

If battery pack is not completely in place, locking tab will not fully turn.

Transmitter

Battery Installation

1. Remove the screw to open the Battery Compartment Cover. Pull back on the tab and slide in the direction indicated by the arrow.
2. Insert 2 “AA” size batteries. Make sure the positive(+) and negative(-) markings on the batteries match up to the ones inside the Battery Compartment.
3. Replace the Battery Compartment Cover and replace the screw.

Note : When replacing Transmitter batteries:

• Use alkaline batteries only.
• Do not mix old and new batteries.
• Do not mix alkaline, standard or rechargeable batteries.

Transmitter

Features and Functions

• This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be raced at the same time.
• Once transmitter batteries have been correctly installed and vehicle ON/OFF Switch is in the ON position, the transmitter will automatically sync with the vehicle.
• Note:
  This vehicle has working lights. When driving forward or reverse the lights will turn on.

Proper Use

Precautions and Care

Support

Troubleshooting & Support

Problem -Vehicle does not move or moves slowly.

• Make certain there are fresh batteries in the transmitter and that they have been installed in the correct position.
• Are the(+) and (-) markings on the batteries in the same position as the(+) and(-) markings in the Transmitter Battery Compartment?
• Has the Battery Pack been installed in the vehicle?
• Has the rechargeable Battery Pack been fully charged?
• Are the(+) and(-) markings on the Battery Pack in the same position as the(+) and (-) markings in the Battery Compartment?
• Are the metal contact tabs touching, rusty or dirty in the transmitter?
• Make certain that the vehicle ON/OFF switch is in the “ON” position.

Problem -Vehicle moves by itself or exhibits reduced range from the transmitter.

• Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur.

F. C.C. CAUTION

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

New Bright

Cautions

• Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery Pack to cool before recharging. Recharging a hot or warm Battery Pack will shorten the life of the Pack.
• Do not recharge a Battery Pack if it appears to be damaged or leaking.
• Always unplug Battery Charger when not in use.
• Always remove Battery Pack from Battery Compartment when not in use.
• Do not dispose batteries in fire. Leakage, explosion and personal injury may occur.
• Dispose of Lithium-Ion Battery Pack properly.
• Do not attempt to disassemble Battery Pack or Charger.
• Do not use Battery Charger for any use other than instructed in this booklet.
• Only an adult should charge Batteries.
• Do not attempt jumps or tricks with this vehicle.

Warranty Information

USA&Canada
30-Day Limited Warranty
New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such defect within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accident, misuse or abuse.
Should your item have a defect covered under this warranty, first call the toll free number listed below. Most problems can be resolved in this manner. If necessary, you will be issued a Return Authorization number (RA) and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer).
When returning a defective product, please package the product, the Product Return Form and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location).
New Bright Industries’ liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages (except in those states that do not allow this exclusion or limitation).
Valid only in the USA & Canada.
Contact New Bright Industries Customer Service Toll Free at:
1-877-NBI-TOYS
( 1-877-624-8697)
Monday through Friday, 8:00 AM to 5:00 PM Eastern Time

U.S. Toy Sales and Marketing Co. Inc. 30260 Oak Creek Drive – 2nd Floor Wixom Ml 48393
1-877-624-8697
http://www.newbright.com/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>