NEW BRIGHT 6420B4 TOY Receiver User Manual
- June 5, 2024
- NEW BRIGHT
Table of Contents
OWNER’S MANUAL
Please read and understand all precautions prior to use.
Thank you for choosing a premium New Bright product.
USA &Canada
30-0ay Limited Warranty
New Bright Industries warrants to the original purchaser that this product
will be free of defects in materials and workmanship for thirty (30) days from
the date of purchase. In the event of such a defect within the warranty
period, New Bright will repair or replace the product at our sole discretion.
This warranty does not cover damage resulting from unauthorized modifications,
accidents, misuse, or abuse.
Should your item have a defect covered under this warranty, first call the
toll-free number listed below? Most problems can be resolved in this manner.
If necessary, you will be issued a Return Authorization number (RA) and
instructions on how to obtain a Product Return Form. The Product return Form
Is to be used when returning a product to us (postage pre-paid and Insured by
the consumer).
When returning a defective product, please package the product, the Product
Return Form, and a copy of the dated sales receipt as proof of purchase. Be
sure to mark the RA number on the Product Return Form. If the product is
returned without a dated sales receipt, it will be excluded from coverage
under this warranty. Please allow 4 to 6 weeks for delivery of repaired or
replacement vehicles (depending on your location).
New Bright Industries’ liability for defects in materials and workmanship
under this warranty shall be limited to repair or replacement at our sole
discretion. In no event shall we be responsible for incidental, consequential,
or contingent damages (except in those states that do not allow this exclusion
or limitation).
Valid only in the USA & Canada.
Contact New Bright Industries Customer Service Toll-Free at:
1-877-NBI-TOYS
(1-8n-624-8697)
Monday through Friday, 8:00 AM to 5:00 PM Eastern Time
U.S. Toy Sales and Marketing Co. Inc.
30260 Oak Creek Drive – 2nd Floor
Wixom Ml 48393
1-877 -624-8697
http://WWW.newbright.com/
This device complies with Part 15 of the FCC Rules: Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
TRANSMITTER BATTERY INSTALLATION
Note: When replacing batteries:
Use alkaline batteries only.
Do not mix old and new batteries..
Do not mix alkaline, standard, or rechargeable batteries.
TRANSMITTER FUNCTIONS & HOW TO DRIVE
Auto pairing:
- 1nstall alkaline batteries in the transmitter.
- Turn vehicle ON/FF switch to the ON posit on.
- The indicator light on the transmitter will flash for pairing.
- When the indicator light stops flashing pairing is complete. You are now ready to play.
Note: The vehicle has working lights. When driving forward or reverse the lights will turn on.
VEHICLE FUNCTIONS
Steering Trim:
If the vehicle veers to the left or right. adjust steering trim on the
underside of the vehicle until the desired alignment is reached.
CHARGING INSTRUCTIONS
Operation:
- Move the switch on the bottom of the vehicle to the ‘OFF” position
- Raise the charging plug at top of the controller.
- Align vehicle as shown.
- Plug the charging stick into the charging port on the underside of the vehicle
- Press any joystick on the controller to begin charging. The charging indicator light on the controller will turn on
- When charging is completed, in approximately 8-10 minutes. the charging indicator light will turn off.
TROUBLESHOOTING & SUPPORT
Problem -The vehicle does not move or move slowly.
- Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
- Are the ( +) and H markings on the alkaline batteries in the same position as the ( +) and H markings in the Transmitter Battery Compartment?
- Has the internal battery in the vehicle been beeO.charged?
- Are the metal contact tabs touching, r\Jsty or dirty in the transmitter?
- Make certain that the vehicle ON/OFF switch is in the “ON’ position.
Problem
- The vehicle moves by itself or exhibits reduced range from the transmitter.
- Make certain there is no outside radio interference in your area. The best way to test this is to take the
- vehicle as far away from radio towers, electrical lines, or tall buildings as possible to ensure no further radio interference will occur.
Always remove batteries from the transmitter when not in use.-·
Do not dispose of batteries in a fire. Leakage, explosion, and personal injury
may occur.
Do not attempt jumps or tricks with this vehicle.
Do not attempt to remove the internal battery.
Adult supervision is recommended.
PROPER USE, PRECAUTIONS & CARE
F.C.C. CAUTION:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user”s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the ll! nuts for a
Class B digital device, pursuant to Part t 5 or the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates. uses and can radiate
radio frequency energy and. tt not installed and used in accordance with the
instructions. may cause harmful interference to radio communications. However,
there Is no guarantee that interference will not occur In a particular
installation. ii this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on.
the user Is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment Into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.