NEW BRIGHT 61538U RC Vaughn Gittin Jr. Ford Bronco Rock Crawler Instruction Manual
- June 4, 2024
- NEW BRIGHT
Table of Contents
61538U RC Vaughn Gittin Jr. Ford Bronco Rock Crawler
Instruction Manual
Please read and understand all precautions prior to use.
Thank you for choosing a premium New Bright product.
USA & Canada
30-Day Limited Warranty
New Bright Industries warrants to the original purchaser that this product
will be free of defects in materials and workmanship for thirty (30) days from
the date of purchase. In the event of such a defect within the warranty
period, New Bright will repair or replace the product at our sole discretion.
This warranty does not cover damage resulting from unauthorized modifications,
accidents, misuse or abuse.
Should your item have a defect covered under this warranty, first call the
toll-free number listed below. Most problems can be resolved in this manner.
If necessary, you will be issued a Return Authorization number (RA) and
instructions on how to obtain a Product Return Form. The Product Return Form
is to be used when returning a product to us (postage pre-paid and insured by
the consumer).
When returning a defective product, please package the product, the Product
Return Form, and a copy of the dated sales receipt as proof of purchase. Be
sure to mark the RA number on the Product Return Form. If the product is
returned without a dated sales receipt, it will be excluded from coverage
under this warranty. Please allow 4 to 6 weeks for delivery of repaired or
replacement vehicles (depending on your location).
New Bright Industries’ liability for defects in materials and workmanship
under this warranty shall be limited to repair or replacement at our sole
discretion. In no event shall we be responsible for incidental, consequential
or contingent damages (except in those states that do not allow this exclusion
or limitation).
Component Checklist
- (1) R/C Vehicle With USB Cord
- (1) Transmitter
- (2) “AA” Batteries
Vehicle Features and Functions
The ON/OFF Switch controls the main power to the vehicle. To save battery
life, always remember to put the switch in the OFF position when not in use.
The 4 Wheel Drive Flexible Chassis gives the vehicle the ability to climb
steep angles. Each wheel has independent suspension during forward and
reverses drive. The vehicle also has elongated shocks and soft tires that help
grip the ground.
The steering Trim Dial is found in between the front wheels on the bottom side
of the chassis, under the vehicle body. If the vehicle pulls to the left or
right during forward driving the Steering Trim may need to be adjusted.
Charging the Battery
This vehicle is equipped with an internal Lithium-Ion battery that is
recharged via USB.
ON/OFF Switch must be in the OFF position prior to charging.
- Locate the ON/OFF switch and USB cord on the underside of the vehicle.
- Turn the ON/OFF switch to the “OFF” position.
- Slide open the Storage Compartment cover.
- Remove the USB cable from the Storage Compartment. (Use care when extending the cord as it is attached to the inside the internal battery). The cord can be plugged into any computer or USB outlet adapter (not included).
- While charging, the LED under the vehicle will be on. Once fully charged the LED will turn off. Charging is completed in approximately 1.5 hours depending on the type of charging device you use. Return cord and secure storage lid before operating the vehicle.
Battery Installation
Note: When replacing Transmitter batteries: Use alkaline batteries only. Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries.
TRANSMITTER F eatures and Functions
This
transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles
to be raced at the same time.
The transmitter will automatically sync with the vehicle.
Precautions and Care
Switch the vehicle OFF when not in use.|
---|---
Brush areas where dirt gets trapped.|
Wipe the body with a soft rag or tack cloth.|
Do not use chemicals or water to clean.|
Trouble Shooting & Support
Problem -The vehicle does not move or move slowly.
– Make certain there are fresh alkaline batteries in the transmitter and
that they have been installed in the correct position.
– Are the (+) and (—) markings on the alkaline batteries in the same position
as the (+) and (—) markings in the Transmitter Battery Compartment?
– Are the metal contact tabs touching, rusty or dirty in the battery
compartment?
– Has the vehicle been fully charged?
– Make certain that the vehicle ON/OFF switch is in the “ON” position.
Problem -The vehicle moves by itself or exhibits reduced range from the
transmitter.
– Make certain there is no outside radio interference in your area. The best
way to test this is to take the vehicle as far away from radio towers,
electrical lines, or tall buildings as possible to ensure no further radio
interference will occur.
Always remove Batteries from the transmitter when not in use.
Do not dispose of batteries in a fire. Leakage, explosion, and personal injury
may occur.
Do not attempt jumps or tricks with this vehicle.
Do not attempt to remove the internal battery.
Do not use included USB cord for anything other than its intended purpose.
Always keep the USB cord stored when not in use.
Adult supervision is recommended.
F.C.C. CAUTION:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Valid only in the USA & Canada.
Contact New Bright Industries Customer Service
Toll-Free at: 1-877-NBI-TOYS
(1-877-624-8697)
Monday through Friday, 8:00 AM to 5:00 PM Eastern Time
U.S. Toy Sales and Marketing Co. Inc.
30260 Oak Creek Drive — 2nd Floor
Wixom MI 48393 1-877-624-8697
http://www.newbright.com/