AMP Lighting AAL-1041-4-B-BZ Low Voltage Landscape Lighting Instruction Manual
- June 6, 2024
- AMP Lighting
Table of Contents
AAL-1041-4-B-BZ Low Voltage Landscape Lighting
Instruction Manual
Important Safety Instructions: Read Before Installation
This luminaire is intended for installation in accordance with local codes and
the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance, or mounting situations.
- Make sure that the power is turned OFF before installing or servicing this luminaire.
- WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or more from the pool, spa, or fountain.
- This luminaire is intended to be used only with a power supply (transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
- Wiring connections must be made with UL-listed wire connectors that are suitable for outdoor use.
- Position the low voltage wire and wire connector so that it is located within 6 inches (15.2 cm) from a building structure, a luminaire, or fitting.
- The main low voltage cable is intended for shallow burial – less than 6 inches (152 mm).
Important Safety Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
The lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
- Turn off/unplug and allow to cool before replacing the lamp.
- The lamp gets HOT quickly! Contact only switch/plug when turning on.
- Do not touch the hot lens, guard, or enclosure.
- Keep the lamp away from materials that may burn.
- Do not touch the lamp at any time. Use a soft cloth. Oil from the skin may damage the lamp.
- Do not operate the luminaire fitting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
Package Contents
A. (1) Fixture Body
Parts Required (sold separately)
A. (1) Stake
Product Dimensions
Install Stake
Determine the desired location for mounting the stake mount.
Hammer the stake into the ground until the flange of the stake is flush to
grade. To avoid damage to the stake, place a board on top of the stake while
hammering.
Note: If the ground is hard and the stake is difficult to install, make a
crosscut in the ground using a flat shovel.
Install Fixture Body to Stake
Clear away an area in the ground at the wire way slot on top of the stake. Lay the fixture wire into the wire way slot. Thread the fixture body onto the stake and hand tighten until snug.
Wire Connections
Strip both leads from the fixture body supply wires. Using two UL-listed wire connectors (sold separately), connect supply wires from the fixture body to the main supply cable leads.
Adjust Luminaire Direction
Loosen the handle at the joint of the fixture body and then adjust the luminaire to your desired direction. Always tighten the handle once your desired direction is achieved.
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
Specifications and product details are subject to change without notice.
© Copyright 2021, AMP®
Lighting, Lutz FL USA 33549 • All rights reserved.
customersupport@amplighting.com •
813.978.3900
www.amplighting.com
IS-AAL-1041-4-B-BZ-ver1.pdf
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>