NEW BRIGHT 21HBRRHW Toy Transmitter Owner’s Manual

BRIGHT 21HBRRHW Toy Transmitter
Owner’s Manual

Please read and understand all precautions prior to use.
Thank you for choosing a premium New Bright product.

Component Checklist

• (1) R/C Vehicle With USB Cord
• (1) Transmitter
• (2) “AA” Batteries

Features and Functions

If the vehicle pulls to the left or right during forward driving the Wheel
Alignment may need to be adjusted. The Wheel Alignment Dial is located on the bottom of the chassis between the front wheels.

Charging the Battery

This vehicle is equipped with an internal Lithium-Ion battery that is recharged via USB. ON/OFF Switch must be in the OFF position prior to charging.

1. Locate the ON/OFF switch and USB cord on the underside of the vehicle.

2. Turn the ON/OFF switch to the “OFF” position.

3. Open Storage Compartment cover.

4. Remove the USB cable from the Storage Compartment. (Use care when extending the cord as it is attached to the inside internal battery). The cord can be plugged into any computer or USB outlet brick (not included).
   

5. While charging, the LED under the vehicle will be on. Once fully charged the LED will turn off. Charging is completed in approximately 1.5 hours. Return cord and secure storage lid before operating the vehicle.

Battery Installation

Note: When replacing Transmitter batteries Use alkaline batteries only
Do not mix old and new batteries standard
Do not mix alkaline or rechargeable batteries
Features and Functions

Note:
The vehicle has working lights. When driving forward or reverse the lights will turn on.
This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be raced at the same time.
The transmitter will automatically sync with the vehicle.

Precautions and Care

Trouble Shooting & Support

Problem – The vehicle does not move or move slowly.

• Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
• Are the (+) and (–) markings on the alkaline batteries in the same position as the(+) and(-) markings in the Transmitter Battery Compartment?
• Are the metal contact tabs touching, rusty or dirty in the transmitter?
• Has the vehicle been fully charged?
• Make certain that the vehicle ON/OFF switch is in the “ON” position.

Problem – Vehicle moves by itself or exhibits reduced range from the transmitter.

• Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur.

Always remove Batteries from the transmitter when not in use.
Do not dispose of batteries in a fire. Leakage, explosion, and personal injury may occur.
Do not attempt jumps or tricks with this vehicle.
Do not attempt to remove the internal battery.
Do not use included USB cord for anything other than its intended purpose.
Always keep USB cord stored when not in use.
Adult supervision is recommended.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)) this device may not cause harmful interference, and (2) this device must accept any interference received. including interference that may cause undesired operation.

FCC CAUTION:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help

USA & Canada
30-Day Limited Warranty
New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such a defect within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accidents, misuse, or abuse
Should your item have a defect covered under this warranty, first call the toll-free number listed below? Most problems can be resolved in this manner. If necessary, you will be issued a Return Authorization number (A) and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer)
When returning a detective product, please package the product, the Product Return Form, and a copy of the dated sales receipt as proof of purchase. Be sure to mark the A number on the Product Return Form. I the product is returned without a dated sales receipt, it wil be excluded from coverage under this warranty. please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location)
New Bright Industries’ liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential, or contingent damages (except in those states that do not allow this exclusion or limitation)

Valid only in the USA & Canada.
Contact New Bright Industries Customer Service Toll-Free at
1-877-NB1-TOYS
(1-877-624-8697)
Monday through Friday, 8.00 AM to 5.00  PM Eastern Time
U.S. Toy Sales and Marketing Co.Inc
30260 Oak Creek Drive 2nd Floor
Wixom MI 48393
1-877-624 8697
http://www.newbright.com/
JN114-20

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>