VANKYO Gaming Headset Captain 100 User Manual
- June 6, 2024
- VANKYO
Table of Contents
VANKYO Gaming Headset Captain 100
PACKING LIST
- Gaming Headset Captain 100
- USB Transmitter
- Detochoble Noise-cancelling Microphone
- Charging Cable
- 3.5mm Audio Cable
- Audio/Mic Splitter Adapter
- User Manual
PRODUCT OVERVIEW
- Microphone On/Off Switch
- Volume Control Wheel
- 3.SmmAudio Jack
- MicrophoneJack
- LED Light On/Off
- LED Light
- Power On/Off
- Charging Port
- Power Indicators
CHARGING
Step l:
Connect the Charging Cable to the Charging port on the headset.
Step 2:
Plug the other end into a USB power source.
Power Indicators:
Tips:
- It takes 3 to 4 hours to reach a full charge.
- When the battery is low, the bottom Power Indicator will flash blue, and you will hear a voice prompt of low battery from the headset.
MICROPHONE INSTALLATION AND OPERATION
install the Microphone
Step 1:
Align point A on the microphone with point Bon the Microphone Jack of the
he.ids et, then plug into the microphone.
Step 2:
Slide the Volume Control Wheel to .idjust the volume to a proper
level.
Mute/Unmute the Microphone
Option 1:
Adjust the Microphone On/Off Switch to mute/unmute the microphone.
Xbox ONE”
Option l:
Xbox(Old Version) Note:
The old version does not have a built-in 3.5mm audio jack. To connect with the
Captain 100, please prepare a headset adapter (not included) by yourself.
Option 2:
Xbox OneS/X Note:
The new version has a built-in 3.5mm audio jack,you can connect the Cap!Ein
100 with your Xbox One S/X directly,
Playstation”‘
Option l; Option 2:
TIPS AND RECOMMENDATIONS
- Do not try to disassemble the product by yourself, please contact VANKYO for more help.
- Do not use the product in high temperatures, and near heat or fire.
- Please use the charging cable provided to charge the product.
- Long exposure to loud volume may cause hearing damage. It’s advised you adjust the volume to a proper level for use.
- For your safety, it’s not recommended to wear the headset when driving as it may resu It in distractions.
- Please pay attention to the surroundings when you use the product in case of potential risks.
TROUBLESHOOTING GUIDE
Ql. My teammate can’t hear me.
- The connection option 11aries from different devices. Please make sure you have plugged in the USB Transmitter u nd.:.r wireless connection and the 3.5mm Audio Cable under wired connection .
- Make sure the microphone has been installed and turned on.
- Make sure the connected device is not muted.
- Please go lo the sound settings of the connected device lo check and verify the headset microphone has been enabled.
- Please contact us directly if this issue is unresolved.
Q2. The sound is intermittent or breaks up.
This is likely to be due to the network connection of your device, and not the headset itself, If operating a wireless network, move your device closer to the router, or provide a wired connection between the router and your device. Determine if other users are overloading the wireless network that is precluding your device from being allocated sufficient bandwidth.
Q3. There ls no sound from one side of the headset when connecting with PC.
- Please insert the headset into your mobile phone to check whether it works well. If yes, please restart the PC and connect the headset with PC again.
- Please go to the sound settings of your PC to check L/R balance.
- Please con!Ect us directly if this issue is unresolved.
Q4. The sound crackles or hisses.
- Excessive static electricity may cause abnormal noises in the headset, please try to remove it.
- Other sources of interference may be too dose, such as TV, refrigerator, power tools etc., please be away from them when using the headset.
FCC Caution
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference wi II not occur in a particular installation. lflhis equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Re<irient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consu It the dealer or an experienced radio(TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
ISEDC Warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS
The symbol indicates DC voltage
This product bears the selective sorting symbol for Waste electrical and
electronic equipment (WEEE). This means that this product must be handled
pursuant to European directive 2012/19/EU in order to be recycled or
dismantled to minimise its impact on the environment. User has the choice to
give his product to a competent recycling organization or to the retailer when
he buys new electrical or electronic equipment.
This product can be used across EU member states.
EU Compliance Statement: Shenzhen Van Top Technology& Innovation Co., Ltd.
hereby de dares that this device is in compliance with the essential
requirements and other relevant provisions of the Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available online at
https://doc.vantop.com/.
NOTES:
- High Sound Pressure
- Hearing Carnage Risk
- Do not listen at high volume levels for long periods.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>