COMMSCOPE PIM Guard SnapTak Hanger Instruction Manual
- July 17, 2024
- CommScope
Table of Contents
COMMSCOPE PIM Guard SnapTak Hanger
Specifications:
- Product Name: PIM Guard SnapTak Hanger: SSH-3642
- For Cable Diameter: 36-42mm
- Main Support Members : 2
- Cable Diameter Range: 36.00mm (1.41in) min to 42.00mm (1.65in) max
Product Usage Instructions
Installation:
- Identify the main support members and gripping tabs on the SnapTak hanger.
- Insert the cable between the main support members.
- Squeeze the gripping tabs and insert the SnapTak hanger into a 3/4-inch hole.
- The hanger can be snapped into other CommScope Snap-in hangers or adapters.
Removal:
- Squeeze the gripping tabs to remove the SnapTak hanger carefully
- Be cautious not to damage the latches during installation or removal from the hole.
WARNING: Be careful not to damage latches when the hanger is installed and removed from the hole.
CommScope
- 3642 E US Highway 70, Claremont, NC 28610 USA
- 828-324-2200 800-982-1708
- www.commscope.com
Customer Service 24 hours
- Technical Support: +1 888 297 6433,
- Option 3 (Toll Free US and Canada): +1 828 323 4220,
- Option 3 (local): https://www.commscope.com/wisupport(open a ticket)
Notice : CommScope disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
© 2024 CommScope Bulletin 7860089 Rev.A
FAQ
Q: Can the SnapTak hanger be used for cables outside the specified diameter
range?
A: It is recommended to use the SnapTak hanger within the specified cable
diameter range of 36-42mm for optimal performance and safety.
Q: Can the SnapTak hanger be stacked with other hangers?
A: Yes, the SnapTak hanger is stackable with compatible CommScope Snap-in
hangers or adapters.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>