Stork LAB11993A Camera Complete Baby Monitoring System User Guide
- June 13, 2024
- STORK
Table of Contents
Stork LAB11993A Camera Complete Baby Monitoring System
Product Information
The Stork Camera is a versatile baby monitoring device that can be mounted on a wall or placed on a flat surface. It allows parents to keep an eye on their baby from a distance using the Stork app. The camera comes with a camera mount, camera power cable, camera power adapter, wall anchors, screws, and camera cable covers. The camera can be rotated and tilted to adjust the view as needed. Please note that the Stork Camera is not intended for use as a medical device or to replace a medical device.
What’s in the box
Not intended for use as a medical device or to replace a medical device. Do not use it to diagnose, cure, treat, alleviate, or prevent any disease or health condition.
Set up the camera
The Stork Camera can be set on a flat surface or mounted to the wall
(preferred). If set on a flat surface, place the camera in a safe location so
as not to fall on anyone, and where alert sounds can be heard clearly. For
wall mounting, pick a spot on the wall near the crib that is 4 to 5 feet above
the mattress. Ideally, it should be located somewhere near the middle of the
crib. At this height, the camera can monitor the whole crib. The camera needs
to be located within reach of a wall outlet using the included power cable. No
matter the camera location, the camera can be rotated and tilted forward or
backward if you need to adjust the view.
OWNER’S MANUAL
Refer to the online manual for other functions, information, and operation
details. masimostork.com/camera-user-manual
Mount the Camera on the Wall
- Place the camera mount on the wall with the center of the mount 4-5 feet above the crib mattress, near the center of the crib. Make sure the wall mount is level and the 4 hooks are facing up, then mark the locations of the screw holes.
- Drill the 2 marked locations with a 1/4” (6mm) drill bit.
- Tap the 2 wall anchors into the holes until they are flush with the wall.
- Secure the mounting plate onto the wall with the included screws.
- Align the 4 holes on the camera base with the hooks on the mounting plate, slide the camera down to snap it in place.
- Peel off the sticky pad liners on the back of the cable cover(s) to apply, starting at the camera. Add more covers as needed.
Attach USB Cable to Camera
Pair camera to the app
Download the Stork app and follow instructions.
The app screens shown in this document might differ from the actual ones displayed in the app.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>