easee Equalizer Charging Robot User Guide
- June 6, 2024
- easee
Table of Contents
User guide / Installation guide
Equalizer
IMPORTANT:
Read carefully before use.
Keep for future reference.
Introduction
Intended use
This product is intended for optimizing the power consumption by performing an automatic load balancing between the Easee Charging Robot(s) and the building. It avoids overload and power interruption while charging the electric vehicle (EV). In the event of unstable or non operational WiFi the device has a redundant Easee Link RF™ connection. Easee Link via radio may be limited by walls, concrete or other obstacles.
The product needs to be paired with a Charging Robot and connected to a compatible smart meter with the cable provided. In order for the Equalizer to work, the smart meter’s communication port in most cases needs to be activated. The Equalizer supports several smart meters. Find a full list of compatible meters at easee.support.
The product may only be operated with the approved operating parameters and under the specified environmental conditions (-20 °C to +50 °C). Do not use the product if it is damaged or does not function properly. Uses other than those specified here are not permitted.
What is included?
Equalizer
- Magnetic backside
- Touch button
- LED
Cable
Wall mounting kit
For non-metallic surfaces
x1 x1
Equalizer installation guide
Customer setup
1 HAN port Activation
In Scandinavia, the communication port on the smart meter is most likely not activated. Contact your utility company to open the HAN port for use with the Equalizer.
2 Easee app Download
Scan the QR code to download the Easee app and create a free account. The app is available on App Store and Google Play.
3 Equalizer Setup
Add the Equalizer in the app, follow the on-screen installation guide and get ready to balance your energy smarter than ever before!
NOTICE! Follow these steps if you are a private customer installing the Equalizer in your own household.
Equalizer installation guide
Installer setup
1 Installer app Download
Scan the QR code to download the Installer app and create a free account. The app is available on App Store and Google Play.
2 Equalizer Setup
Add the Equalizer to a new or existing charging site using the Installer app
and follow the on-screen installation guide to set it up.
Smart meter
3 Smart meter Connect
Connect the Equalizer to the smart meter using the provided cable. The Equalizer will appear in the Easee Portal after a while.
NOTICE! Follow these steps if you are an Installer and use the Installer app to configure the Equalizer in large commercial installations or private households.
Technical specifications
General
Product (mm): H: 110 x W: 110 x D: 27.5
Packaging (mm): H: 130 x W: 130 x D: 39
Operating temperature: -20 °C to +50 °C
Weight: 95 g (P1 version) and 110 g (HAN version)
IP degree: IP40
Supply: 5-32 VDC 100 mA (P1 version) and 20-32 VDC 30 mA (HAN version)
RJ12 connector
Max transmitted power
Radio: 25 mW at 863-870 MHz.
WiFi: 50 mW at 2.4-2.472 GHz.
Installation
Cable length: 1.5 m
RJ11 to RJ11 custom made cable (P1 version) and RJ11 to RJ45 custom made cable
(HAN version)
It can be extended up to 200 m using an extension cable
Connectivity
Easee Link RF™ and WiFi*
HAN or P1 smart meter communication Modbus connection to energy meter Monitor
power consumption with the Easee app RFID / NFC reader
*WiFi is required for normal operation. When offline, it will use Easee Link RF™ as backup in small installations with one primary charger.
Practical details
Charge faster
The Equalizer makes it possible to charge smarter, safer and faster if the installation is scaled accordingly. To enable its true potential, the rated value of the chargers circuit fuse should be as high as possible compared to the main fuse. Even in 1-phase setups, we recommend using a 3-phase cable to future proof the installation.
Protection
The Equalizer is IP40. This means it has no protection against water. If placed outside the house, it must be installed inside a cabinet protected from the weather.
Warranty
The device is free from material defects and is in accordance with laws and regulations for consumer protection in the country where the product is purchased. All correctly installed Easee hardware is covered by our 3 years limited warranty.
Standards
The EU Declaration of Conformity is available at the following address: easee.support.
Maintenance
This product requires no maintenance. If it needs to be repaired, please contact your Easee supplier.
Storage
The product should be stored in a tempered, dry and well-ventilated area in order to preserve the packaging and its contents. Relative humidity should not exceed 80 % and no corrosive gas should be present. Storage or transportation environment should never exceed the limits provided in the technical specifications.
Disposal
This electronic equipment must not be disposed of in household waste. For the return of old devices, free collection and acceptance points may be available in your vicinity. Observe local regulations for correct and environmentally friendly disposal.
Returns and complaints
Contact your distributor or Easee Customer Support at easee.support regarding the return and complaint of your product.
Contact details
Easee AS
Grenseveien 19
4313 Sandnes, Norway
Org. nr: 920 292 046
You can find additional contact details for your country at easee.com.
THIS DOCUMENT CONTAINS INFORMATION THAT IS SUBJECT TO CHANGE WITHOUT NOTICE.
The latest version of this publication can be downloaded at http://easee.support
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including, but not limited to, copying, recording, retrieving data, or computer networks without the written permission of Easee AS.
Easee and all other Easee product names and slogans are trademarks or registered trademarks of Easee AS. Easee products can be protected by one or more patents.
All other products and services mentioned may be trademarks or service marks of their respective owners.
Illustrations of the product and user interface are exemplary and may differ from the actual appearance.
September 2021 – Version 4.00
© 2020 by Easee AS. All rights reserved.
Easee AS
Grenseveien 19
4313 Sandnes, Norway