access LIGHTING 20135LEDDMG 8 Inch Black Outdoor Wall Sconce Instruction Manual

access LIGHTING 20135LEDDMG 8 Inch Black Outdoor Wall Sconce

IMPORTANT SAFETY INSTRUCTIONS

MESURES DE SECURITE A RESPECTURE

• Before assembling your ACCESS LIGHTING fixture, please make sure that you carefully read through this instruction sheet. Save this instruction sheet and refer to it when additions to or changes in the fixture configuration are made.

• CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH
  CIRCUIT CONDUCTOR.

• THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION
  AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

• NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care, are factors that can’t be built into any product. These factors must be supplied by the person(s) caring for and operating the fixture.
  Read all instructions

• Do not install this fixture in hazardous locations.

• Do not install any fixture assembly closer than 6 inches from any curtain or similar combustible material.

• “WARNING Risk of Fire and Electric Shock.”

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances, Local and the U.S. National Electrical Codes (NEC). These fixtures are intended for mounting to a standard 4” metal octagon outlet box. The box must be directly supported by the building structure and U.L. Recognized.

WHAT WE PROVIDE

• Mounting Hardware
• Mounting bracket
• LED

WHAT YOU NEED

• Screwdriver
• Wire Cutters
• Wiring Supplies as Specified by Electrical Code

Recommended Dimmers

• Lutron Maestro MACL-153MH
• Lutron Maestro MAELV-600-WH
• Leviton SureSlide NO.6672

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the Circuit Breaker or by removing the fuse at the fuse box. Just turning the light off at the light switch is not sufficient to prevent electrical shock.

1. PREPARE FIXTURE
   If there is an existing fixture remove it. Expose the supply wires from the J-box. Secure the mounting bracket to the J-box with the supplied screws.

2. MAKE WIRE CONNECTIONS
   Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wire to the white fixture wire. Secure with the supplied wire nuts. Attach the green J-Box wire around green hexagonal head screw or connect it to the green supply grounding wire of the fixture. Secure all wire with electrical tape (not supplied). Tuc k all wires carefully into the J-Bo x.

3. MOUNT FIXTURE TO MOUNTING BRACKET
   Align the fixture over the mounting bracket and secure with the supplied screws. This fixture is wet location rated. In order to ensure that moisture does not enter the outlet box and cause a short circuit, clear caulking should be used to seal the space between the fixture mounting bracket and the wall. Ensure that a space is left at the bottom to allow for the escape of moisture. It is recommended that Outdoor Silicon Sealant is used for that purpose

4. RESTORE THE ELECTRICITY AND CHECK THE OPERATION OF YOUR NEW ACCESS LIGHTING FIXTURE
   CAUTION
   If the fixture is to be removed or replaced, please ensure that the electricity is switched off and that the fitting is cool before touching it.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>