Pablo LANA Series Wall Plate and Table Base LED Lamp Instruction Manual
- June 9, 2024
- Pablo
Table of Contents
LANA
WALL PLATE AND TABLE BASE
ASSEMBLY & INSTALLATION INSTRUCTIONS
LANA MODELS
NOTE: WALL PLATE INCLUDED WITH EVERY MODEL
WALL PLATE INSTALLATION
- IF FIXTURE I S BEING INSTALLED ONTO DRYWALL, USE PROVIDED WALL ANCHOR. TAP THE UNTHREADED TIP OF THE WALL ANCHOR INTO THE WALL, THEN USE A PHILLIPS SCREWDRIVER TO COMPLETE INSTALLATION NOTE: IF MOUNTING ONTO WOODEN STUD, DO NOT USE WALL ANCHOR
- FIX WALL PLATE TO THE WALL USING THE PROVIDED SCREW, ENSURE EDGE OF PLATE IS FLUSH WITH WALL NOTE: WALL PLATE IS INCLUDED WITH EVERY MODEL
TABLE BASE ASSEMBLY
USE PROVIDED 3MM HEX TOOL AND 2 MACHINE SCREWS TO FIX POST TO BASE
FLOOR BASE ASSEMBLY
USE PROVIDED 3MM HEX TOOL AND 3 MACHINE SCREWS TO FIX POST TO BASE
PEDESTAL INSTALLATION (OPTIONAL ACCESSORY)
- USE THE PROVIDED SCREWDRIVER TO UNSCREW CLEAR PLASTIC SET SCREW. SLIDE PEDESTAL OVER FLOOR POST AND TIGHTEN SET SCREW UNTIL IT CONTACTS POST. PEDESTAL SHOULD SLIDE UP AND DOWN EASILY
- SLIDE PEDESTAL TO DESIRED HEIGHT, THEN TIGHTEN KNOB TO FIX IN PLACE
SHADE INSTALLATION
MAGNETIZE SHADE TO WALL PLATE| SHADE INSTALLATION
MAGNETIZE SHADE TO TABLE OR FLOOR POST
---|---
ADJUSTMENT
SWITCH FUNCTION
TAP OPTICAL SWITCH BRIEFLY TO CYCLE THROUGH HIGH, LOW AND OFF. PRESS AND HOLD
OPTICAL SWITCH TO ACTIVATE FULL RANGE DIM CONTROL. RELEASE FINGER FROM OPTICAL
SWITCH WHEN DESIRED LIGHT LEVEL I S REACHED
CARE INSTRUCTIONS
WIPE CLEAN WITH A SOFT DAMP CLOTH. AVOID AMMONIA-BASED CLEANERS
NOTE: CONTACT MANUFACTURER FOR ADDITIONAL PLUG TYPE REQUIREMENTS.
INFO@PABLODESIGNS.COM
888 MARIN STREET
SAN FRANCISCO, CA
94124
PABLODESIGNS.COM
Documents / Resources
|
Pablo LANA Series Wall Plate and Table Base LED
Lamp
[pdf] Instruction Manual
LANA Series Wall Plate and Table Base LED Lamp, LANA Series, Wall Plate and
Table Base LED Lamp, Table Base LED Lamp, LED Lamp, Lamp
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>