access LIGHTING 71015LEDDCS-MIR Peninsula 1 Light 24 Inch Mirror ADA Wall Sconce Wall Light Instruction Manual
- June 12, 2024
- access LIGHTING
Table of Contents
access LIGHTING 71015LEDDCS-MIR Peninsula 1 Light 24 Inch Mirror ADA Wall
Sconce Wall Light
INSTALLATION INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
Before assembling your ACCESS LIGHTING fixture, please make sure that you
carefully read through this instruction sheet. Save this instruction sheet and
refer to it when additions to or changes in the fixture configuration are
made.CONSULT A QUALIFIED ELECTRICIAN TO ENSURE THE CORRECT BRANCH CIRCUIT
CONDUCTOR.
NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care, are factors that can’t be built into any product. These factors must be supplied by the person(s) caring for and operating the fixture.
- Read all instructions Do not install this fixture in hazardous locations.
- Do not install any fixture assembly closer than 6 inches from any curtain or similar combustible material.
- “WARNING Risk of Fire and Electric Shock.”
- “CAUTION: Risque d’ Incendie et de Choc Electriques.”
GENERAL INFORMATION
All electrical connections must be in accordance with all ordinances, Local and the U.S. National Electrical Codes (NEC). These fixtures are intended for mounting to a standard 4” metal octagon outlet box. The box must be directly supported by the building structure and U.L. Recognized.
- COLLECTION
- PENINSULA
- APPLICATION
- WALL
- MODEL NO.
- 71015LEDDCS-MIR
WHAT WE PROVIDE
- Mounting Hardware
- Mounting bracket
- LED
WHAT YOU NEED
- Screwdriver
- Wire Cutters
- Wiring Supplies as Specified by Electrical Code
STEP-BY-STEP INSTRUCTIONS
Before starting your installation disconnect the Power by turning off the Circuit Breaker or by removing the fuse at the fuse box. Just turning the light off at the light switch is not sufficient to prevent electrical shock.
PREPARE THE FIXTURE
If there is an existing fixture remove it. Determine the desired location of
the fixture. Hold the backplate to the surface and with a pencil, mark the
location of the drywall anchors. Drill a hole and insert the supplied drywall
anchors. Secure the mounting hooks to the drywall anchors with the supplied
screws.
MOUNT THE FIXTURE
Plug in the fixture. Gently hang the fixture body onto the mounting hooks
.
TOUCH BUTTON FUNCTION
RESTORE THE ELECTRICITY AND CHECK THE OPERATION OF YOUR NEW ACCESS LIGHTING FIXTURE
CAUTION
If the fixture is to be removed or replaced, please ensure that the
electricity is switched off and that the fitting is cool before touching it.
When using electrical furnishing, basic precautions should always be followed,
including the following: Read all instructions before using (this furnishing).
DANGER – To reduce the risk of electric shock:
- Always disconnect this furnishing from the electrical outlet before cleaning.
WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons:
- Disconnect from the outlet before putting on or taking off parts.
- Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
- Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
- Never operate this furnishing if it has a damaged cord, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
- Keep the cord away from heated surfaces.
- Never operate the furnishing with the air openings blocked. Keep the air openings free of lint, hair, and the like.
- Never drop or insert any object into any opening.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
- To disconnect, turn all controls to the off position, then disconnect from the outlet.
- For grounded products the following statement:
″WARNING: Risk of Electric Shock – Connect this furnishing to a properly grounded outlet only. SAVE THESE INSTRUCTIONS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>