access LIGHTING 62585LEDDLP Pendant Ceiling Light Instruction Manual

INSTALLATION INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

MESURES DE SECURITE A RESPECTURE

Before assembling your ACCESS LIGHTING fixture, please make sure that you carefully read through this instruction sheet. Save this instruction sheet and refer to it when additions to or changes in the fixture configuration are made.
Lisez attentivement ce manuel d’instructions. Enregistrer cette feuille d’instructions et de s’y référer lorsque les ajouts ou changements dans la configuration de montage sont faites.

CONSULT A QUALIFIED ELECTRICIAN TO ENSURE THE CORRECT BRANCH CIRCUIT CONDUCTOR.
CONSULTER UN ELECTRICIAN QUALIFIED POUR VOUS ASSURER QUE LES CONDUCTEURS DE LA DERIVATION SONT ADEQUATE THIS PRODUCT  MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND  OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
CE PRODUIT DOIT ETRE INSTALLE SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE PERSONNE QUI CONNAIT BIEN LE PRODUIT ET  SON FONCTIONNEMENT AINSI QUE LES RISQUES INHERENTS

NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution, and care, are factors that can’t be built into any product. These factors must be supplied by the person(s) caring for and operating the fixture.
Read all instructions
Do not install this fixture in hazardous locations.
N’installez pas cet appareil dans des emplacements dangereux.
Do not install any fixture assembly closer than 6 inches from any curtain or similar combustible material. Laisser une distance d’au moins 6 pouces entre ce luminaire et la toute
surface combustible.
“WARNING Risk of Fire and Electric Shock.”
“CAUTION: Risque d’ Incendie et de Choc Electriques.”

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances, Local and the U.S. National Electrical Codes (NEC). These fixtures are intended for mounting to a standard  4” metal octagon outlet box.
The box must be directly supported by the building structure and U.L. Recognized.

WHAT WE PROVIDE
• Mounting Hardware
• Mounting bracket
• 1 x Glass shade
• 1 x 6”, 16”, 22” rod
• 1 x A19 E26 LED bulb| WHAT YOU NEED
• Screwdriver
• Wire Cutters
• Wiring Supplies as Specified by Electrical Code
---|---

Recommended Dimmers for Supplied LED bulb
(TRIAC) LEVITON Decora Sureslide 6672
(TRIAC) LEVITON Decora Sureslide 6674
(TRIAC) LUTRON Toggler TGCL-153P
(TRIAC) LUTRON Diva DVCL-153P
(TRIAC) LUTRON Skylark CL SCL-153 or SCL-153P

STEP-BY-STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the Circuit Breaker or by removing the fuse at the fuse box. Just turning the light off at the light switch is not sufficient to prevent electrical shock.

PREPARE THE FIXTURE
If there is an existing fixture remove it.
Determine the desired hanging height and secure the included rods to the canopy and fixture.
Carefully pass the fixture wires through the rods to the canopy.
Expose the supply wires from the outlet box.

MOUNT THE MOUNTING BRACKET AND MAKE A WIRE CONNECTION
Attach the mounting bracket to the J-Box with the supplied screws. Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wire to the white fixture wire. Secure with the supplied wire nuts. Attach the green J-Box wire around the green hexagonal head screw or connect it to the green supply grounding wire of the fixture. Secure all wires with electrical tape (not supplied). Tuck all wires carefully into the J-Box. Align the canopy to the mounting bracket and secure it with the supplied screws.

INSERT THE GLASS SHADE AND THE BULB
Place the glass shade over the socket. Secure with the supplied socket ring.
Insert the bulb.
DO NOT EXCEED THE MAXIMUM WATTAGE AS STATED ON THE WARNING LABEL

RESTORE THE ELECTRICITY AND CHECK THE OPERATION OF YOUR NEW ACCESS LIGHTING FIXTURE

CAUTION
Please ensure that the fitting is cool and switched off before replacing the bulb.
DO NOT use bulbs that exceed the maximum wattage, stated on the caution label.

CERTIFICATION: cULus DRY
NO. 62585EDDLP

Documents / Resources

| access LIGHTING 62585LEDDLP Pendant Ceiling Light [pdf] Instruction Manual
62585LEDDLP, Pendant Ceiling Light, 62585LEDDLP Pendant Ceiling Light, Ceiling Light, Light
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>