access LIGHTING 52069LEDD Anello Pendant Ceiling Light Instruction Manual
- June 4, 2024
- access LIGHTING
Table of Contents
access LIGHTING 52069LEDD Anello Pendant Ceiling Light Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS
Before assembling your ACCESS LIGHTING fixture, please make sure that you carefully read through this instruction sheet. Save this instruction sheet and refer to it when additions to or changes in the fixture configuration are made.
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations that may
occur. It must be understood that common sense, caution and care, are factors
that can’t be built into any product. These factors must be supplied by the
person(s) caring for and operating the fixture.
Read all instructions.
Do not install this fixture in hazardous locations.
Do not install any fixture assembly closer than 6 inches from any curtain or similar combustible material.
WARNING Risk of Fire and Electric Shock.
GENERAL INFORMATION
All electrical connections must be in accordance with all ordinances, Local
and the U.S. National Electrical Codes (NEC). These fixtures are intended for
mounting to a standard 4” metal octagon outlet box.
The box must be directly supported by the building structure and U.L.
Recognized.
WHAT WE PROVIDE
- Mounting Hardware
- Metal with Acrylic shade
- LED
WHAT YOU NEED
- Screwdriver
- Wire Cutters
- Wiring Supplies as Specified by Electrical Code
Recommended Dimmers
(0-10V) Any 0-10V Dimmer
(ELV) LUTRON Diva DVELV-300P
(ELV) LUTRON Maestro CL MACL-153M
(ELV) LUTRON Skylark Contour CTCL-153P
(TRIAC) LEVITON Decora Sureslide 6672
(TRIAC) LEVITON Decora Sureslide 6674
(TRIAC) LUTRON Diva DVCL-153P
(TRIAC) LUTRON Skylark CL SCL-153 or SCL-153P
STEP BY STEP INSTRUCTIONS
Before starting your installation disconnect the Power by turning off the Circuit Breaker or by removing the fuse at the fuse box. Just turning the light off at the light switch is not sufficient to prevent electrical shock.
-
MOUNT THE MOUNTING BRACKET
If there is an existing fixture remove it. Align the mounting bracket to the junction box and with a pencil, mark the location of the drywall anchors. Drill a hole and insert the supplied drywall anchors. Secure the mounting bracket to the junction box and drywall anchors with the supplied screws. -
MAKE WIRE CONNECTION AND MOUNT THE CANOPY TO THE MOUNTING BRACKET
Expose the supply wires from the J-box. Gently pull the supply wires through the hole in the mounting bracket. Connect the black supply wire to the black driver wire. Secure with the supplied wire nuts. Connect the white supply wire to the white driver wire. Secure with the supplied wire nuts. Attach the green J-Box wire around green hexagonal head screw or connect it to the green supply grounding wire of the fixture. Secure all wires with electrical tape (not supplied). Tuck all wires carefully into the J-Box. If not connecting to 0-10V dimmer, cap off the Grey and Purple wires with supplied wire nuts. Align the fixture canopy to the mounting bracket and secure with the supplied screws. -
RESTORE THE ELECTRICITY AND CHECK THE OPERATION OF YOUR NEW ACCESS LIGHTING FIXTURE
CAUTION
If the fixture is to be removed or replaced, please ensure that the electricity is switched off and that the fitting is cool before touching it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>