LUXOR 64072 LED Strip 90 RGB Light Connector Kit User Guide
- June 6, 2024
- LUXOR
Table of Contents
LUXOR 64072 LED Strip 90 RGB Light Connector Kit
Overview
- On
- Off
- Decrease brightness
- Increase brightness
- Colors
- Color hues
- Flash
- Strobe
- Fade
- Smooth
- Battery tray
Specifications
- Voltage: 12V,2A
- Power consumption: 24W
- LED strip length: 3m
- Power cable length: 1.5 m
- Extension cable length: 4x 10 cm
- IP code: LED strip IP65, adapter IP20
- Width: 10mm
Before use Clean the area where the strips will be attached so the 3M tape can stick to the surface as well as possible.
Application The strip can be cut every 10 cm, it’s indicated with a pair of small scissors where to cut (IP code can’t be guaranteed if cut). Peel off around 5 mm of the plastic casing so the connector points are open and clean. The metal teeth on the extension cable need to have contact with the connector points on the strip. Make sure to place the strips so their markings are the same at all connecting ends (match the markers), as seen below. Close the clamp by pressing the two plastic pieces together. When you’ve matched the ends accordingly peel off the 3M tape and carefully attach the strips. When in place, attach the extension cables and connect the RGB control box and wall plug. There is also a small lR diode on a separate cable on the control box that has to be visible for the remote control to be able to work.
Power on/off Connect the power adapter to a wall plug. Turn on the light strip with the [On] button (1 ). Turn off the light strip with the [Off] button (2).
Set the brightness Press the [Increase brightness] button (4) or the (Decrease brightness] button (3) to adjust the brightness. When a “light scene” is active, the brightness can not be controlled. To adjust the brightness on “light scenes”, change the brightness on a fixed color (5, 6) and then choose the “light scene” again.
Choose colour The light strip can shine in 16 different colors, switch between them by pressing the [Colour buttons] (5) and [Colour hue buttons] (6) on the remote control.
Light scenes [Flash] (7). The strip jumps between all colors. Strobe] (8). The strip fades on and off with white light. [Fade] (9). The strip fades between all colors. [Smooth] (10). The strip fades between red, green, and blue.
Replace battery The battery tray (11) is placed at the bottom of the remote control. Remove it by pushing the lock on the side of the tray at the same time as you pull it out. The battery should be placed with the positive polarity(+) side facing upwards.
Safety information The LED strip can be placed outdoors. Power adapter must be used indoors. Only use the provided power adapter. Oo does not connect power to the strip while it’s in the packaging or wound onto a reel. Do not cover the LED strip or place it in a recess. Do not open the strip (IP code can’t be guaranteed if opened). The LED lights can not be replaced. Depleted batteries should be removed and replaced by a similar kind. Dispose of batteries according to local regulations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>