LUXOR LLMC10 Modular Charging Cabinet Instruction Manual
- October 30, 2023
- LUXOR
Table of Contents
www.luxorworkspaces.com
800-323-4656
LLMC10 Modular Charging Cabinet
Assembly Instructions
Tools Required:
Phillips Head Screwdriver
Parts Key
| | |
---|---|---|---
-
Position cord wrap on the rear of the cabinet, over the corresponding threaded mount holes.
-
Insert each bolt into a lock washer, then a flat washer, then use to attach the casters to the Dolly.
-
Remove the drawer from the bottom/lower cabinet by pressing the release lever on each side of the drawer track.
-
Remove the rubber caps from the top of the cabinet.
-
Position a second cabinet on top, aligning the threaded mount holes.
-
Using the thumbscrews attach the lower Cabinet to the upper Cabinet.
LLMCDP Modular Charging Cabinet – Double Dolly
Assembly Instructions
Tools Required:
Phillips Head Screwdriver
Parts Key
| | |
---|---|---|---
-
Flip the Dolly over and position the casters over the corresponding threaded mount holes.
IMPORTANT: Position the locking casters on the end next to the power strip. -
Insert each bolt into a lock washer, then a flat washer, then use to attach the casters to the Dolly.
-
Using the thumbscrews, attach the Modular Charging Cabinets.
IMPORTANT: Position the Charging Cabinets so the cabinet doors face perpendicular to the edges of the Dolly with the power strips.
LLMCDC Modular Charging Cabinet – Dolly Connection Plate
Assembly Instructions
Tools Required:
Phillips Head Screwdriver
- Phillips head bolts come with the Dolly assemblies.
** Thumbscrews come with the Modular Charging Cabinet assemblies.
Parts Key
| |
---|---|---
-
Flip the Dollies over, position them end-to-end with the power strips facing out, and position the casters at each corner over the corresponding threaded mount holes.
IMPORTANT: Position at least one set of locking casters on one end. If desired, you can place a locking caster at all four corners.
-
Position the Connection Plate over the corresponding threaded mount holes where the two Dollies are joined.
-
Insert each bolt into a lock washer, then a flat washer, then use 16 bolts to attach the casters to the Dollies.
-
Use the remaining 16 bolts to attach Connection Plate to the Dollies.
-
Using the thumbscrews, attach the Modular Charging Cabinets.
IMPORTANT: Position the Charging Cabinets so the cabinet doors face perpendicular to the power strips.
LLMCPH Modular Charging Cabinet – Dolly Handle
Assembly Instructions
-
Line the handle up with the corresponding threaded mount holes on the sides of the Dolly. NOTE: While the handle can be attached to either end, it’s generally best to attach the handle to the end with the power strip and caster locks.
-
Use the socket head bolts and split washers to attach the handle to the Dolly.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>