LUXOR 64075 LED Strip 180 Warm Light Strip Instructions

June 6, 2024
LUXOR

LUXOR 64075 LED Strip 180 Warm Light Strip

LUXOR 64075 LED Strip 180
Warm Light Strip

Specifications

  • Voltage: DC12V
  • Power consumption: 14W
  • LED strip length: 3m
  • Power cable length: 2m
  • Lumen: 1200Im
  • Colour temperature: 35 00 K
  • IP class: LED strip IP65, adapter IP20
  • Width: 8mm

Before use

Clean the area where the strip will be attached so the 3M tape can stick to the surface as good as possible.

Application

If you wish to separate the strip into smaller pieces it is possible to do so. Extension pieces are sold separately. The strip can be cut every 5 cm, it is indicated with a pair of small scissors where to cut (the IP code cannot be guaranteed if cut). Peel off around 5 mm of the plastic casing so the connector points are open and clean. Make sure
to place the strips so their markings are the same at all connecting ends. Match the markers, as seen below.LUXOR 64075 LED Strip 180 Warm Light Strip
1

When you have matched the ends accordingly, peel off the 3M tape and carefully attach the strips. When in place, attach eventual extension cables/pieces and wall plug.

Power on/off

Connect the power adapter to a wall plug.

Safety information

Only intended for household use. The power adapter may only be used indoors. Only use the provided power adapter. Do not connect power to the strip while it is in the packaging or wound onto a reel. Do not cover the LED strip or place it in a recess. Do not open the strip (IP code cannot be guaranteed if opened). The LED lights cannot be replaced. The mains plug is used as the disconnect device, therefore the mains plug shall remain readily operable.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals