DELTA 5042344600 Remote Control Instruction Manual
- June 6, 2024
- Delta
Table of Contents
Remote Control Manual
Model: 5042344600
- Turn the main power source off to begin the learning process.
- Return the power to the unit.
- Within 10 seconds of turning the fan’s AC power ON, press and hold the leaming button for 3 seconds to enter the learning function.
- Once the receiver has detected the set frequency, the light kit of your fan will blink.
| Button | Operating Instructions |
|---|---|
| Fan button |
Press button to turn on the fan power Again press button to turn off the fan
power
Speed control button
Press the number button to fan speed
Lighting button
Press button to turn on the lighting power Again press button to turn off the
lighting power
Lighting control button
Press – or + button to adjust light level
Reverse button
Press button to reverse or forward
Specifications
| Brand | Delta |
|---|---|
| Manufacturer | Delta Electronics Incorporated |
| Equipment type | (X)Transmitter |
| Carrier frequency | 433.92 MHZ ±150KHZ |
| Transmission output | 10 dBm |
| Key quantity | 12 |
| Battery quantity | 2 |
| Battery type | AAA |
| Operation voltage | 2.3V-3.3V |
| Operation current | keypress <25mA |
FCC ID : H795042344600
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
IMPORTANT NOTE:
FCC Radiation Exposure Statement: This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment.