SDC SP403U Saturn Key Retracts Latchbolt Instruction Manual
- June 6, 2024
- SDC
Table of Contents
SECURITY DOOR CONTROLS
WWW.SDCSECURITY.COM
800.413.8783 805.494.0622
E-mail: service@sdcsecurity.com
801 Avenida Acaso, Camarillo,
CA 93012 PO Box 3670, Camarillo, CA 93011
INSTALLATION INSTRUCTIONS
SP403U S4000
SATURN KEY RETRACTS LATCHBOLT
INSTALLING RIM CYLINDER TO PULL PLATE
- Use the template to mark the hole locations on the door. Drill holes onto the door.
- Install rim cylinder using the provided cylinder collar packed with trim. (Do not use any other collar)
- On the backside of the pull plate, place the cylinder retaining cup over the rim cylinder tailpiece.
- Using the 2 break-off screws provided with the rim cylinder, secure the cylinder retaining cup to the rim cylinder.
INSTALLING PULL PLATE
- Insert the 3 mounting posts and cylinder assembly through holes indoors.
- The rim cylinder tailpiece should enter into the exit device cam approximately 7/16″. If the tailpiece is too long and enters the exit device cam more than 7/16, carefully measure and mark the tailpiece at the closest break-off line to achieve the desired 7/16 engagement length. Then using pliers, break tailpiece at marked break-off line.
- Secure the pull plate and the exit device using the 3 supplied mounting screws.
P: INST INSTRUCTIONSEXIT DEVICESINST-SP403U REV – 04-21 Page 1
Any suggestions or comments on this instruction or product are welcome.
Please contact us through our website or email
engineer@sdcsecurity.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>